Heat & Glo LifeStyle 6000TRS-CE manual Installing the Fireplace, Maintaining and Servicing

Page 3

Safety and Warning Information		2
Service Parts List		4
Section 1: Approvals and Regulations		7
Appliance Certiﬁcation		7
Installation Regulations		7
Section 2: Getting Started		8
Introducing the Heat & Glo Gas Fireplaces		8
Pre-installation Preparation		8
Section 3: Installing the Fireplace		10
Step 1	Locating the Fireplace	10
Step 2	Framing the Fireplace	11
Step 3	Installing the Flue System	12
	A. Flue System Approvals	12
	B. Installing Flue Components	20
	C. Flue Termination	24
Step 4	Positioning, Leveling and
	Securing the Fireplace	29
Step 5	The Gas Control Systems	29
Step 6	The Gas Supply Line	30
Step 7	Gas Pressure Requirements	31
Step 8	Wiring the Fireplace	31
Step 9	Finishing	32
Step 10	Installing Trim, Logs & Ember Material	33
	Installing the Trim	33
	Positioning the Logs	34
	Placing the Ember Material	36
Step 11	Before Lighting the Fireplace	37
Step 12	Lighting the Fireplace	38
	After the Installation	38
Section 4: Maintaining and Servicing
	Your Fireplace	39
Section 5: Troubleshooting		41
Limited Lifetime Warranty		44

Î = Contains updated information.

Table of Contents

Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/11

3

Image 3

Contents What to do if you smell gas ModelSafety and Warning Information Maintaining and Servicing Installing the FireplaceService Parts Log Set Assembly6000TRS-CE Service Parts List6000TRS-CE Valve AssemblyAppliance Certiﬁcation Installation RegulationsANY Such Action MAY Possibly Cause a Fire Hazard Location Centimeters Clearance Requirements StepLocating FireplaceFraming should be constructed of 2 X 4 lumber or heavier Step Framing FireplaceStep Installing Flue System Flue System ApprovalsIdentifying Flue Components DVP4 DVP6 DVP12 Straight UP Flue with ONE 1 90o Elbow Flue with TWO 2 90 Elbows Flue with TWO 2 90 Elbows Flue with Three 3 90 Elbows + H Installing Flue Components Venting Out the Rear FlueVenting Out the Top Flue On the TOP of the heater Install Support BracketsInstalling Support Brackets Install FirestopsFlue Pipe & Firestop Flue Termination For Horizontal Terminations using the DVP-TRAPBe Positioned SO That the Arrow is Pointing UP DVP Termination Cap Outside of the building Alcove Applications Standing Pilot Ignition System Step Positioning Leveling, Securing FireplaceStep Gas Supply Line Step Gas Pressure Requirements Optional AccessoriesFinishing Installing the Trim Installing the Ceramic ReFractory LOG Placement Heat & Glo 6000TRS-CE 2049-900 Rev. Q 2/11 Placing the Ember Material Glass AssemblyDouble-check for gas leaks Review safety warnings and cautionsDouble-check for faulty components Step Before Lighting FireplaceStep Lighting Fireplace After the Installation Maintaining Servicing Your Fireplace Make Sure the Flames Standing Pilot Troubleshooting With the pilot lit, and the ON/OFF switch Placed in this Opening Limited Lifetime Warranty Limited Lifetime WarrantyWarranty Conditions