Vermont Casting BHDR36 Optional Screen KIT Installation, Optional Ceramic Refractory Installation

6.Hang Bay Window Frame assembly over existing glass frame.

Do not remove existing glass frame

7. Re-install top louvre assembly.

Remove all plastic from brass trims

8.Open the Bottom Bay Louvre door and screw two (2) self tapping screws (as per step 1 above) to the bottom of the unit where the hinges were

9.Bottom brass trim is removable when unit is installed with marble or tile surround which cover the fireplace bottom.

OPTIONAL SCREEN KIT INSTALLATION

WARNING: DO NOT install the frame window screen with the fireplace ON

To install the Frame Window Screen:

1- Slide the top edge of the frame window screen through the slots beneath the main frame window top trim support.

2- Make the frame window screen parallel to the main frame window.

3- Slide the bottom edge of the frame window screen into the space that exist between the glass and the main frame window bottom trim support.

To remove the Frame Window Screen:

WARNING: If the fireplace is ON, turn it OFF and wait until the temperature of the window screen is cool enough to handle.

1- Lift the frame window screen moving it parallel to the glass.

2- Move the bottom side of the frame window screen away from the glass.

3- Slide the frame window screen down from the top trim support.

OPTIONAL CERAMIC REFRACTORY

INSTALLATION

1.Remove glass and logs.

2.Place refractory side supports so that the hole fits over the screw head on the firebox floor.

3.Place refractory base sides on the floor of the firebox.

4.Place back refractory - small brick edge down into support (See Fig. 79).

5.Attach adjustable tabs, packed with refractory, onto the studs found on the top of the firebox using the 2-10/ 24 nuts provided.

6.Slide side panels into side supports and behind side tab and adjust, fitting the ceramic tight to the side of the firebox. Tighten nuts. Fig. 78.

Mortar lines must be lined up.

7. Place refractory base centre in front of the burner.

- 36 -