DVS 30-2 installation instructions Positioning the Fireplace

INSTALLATION (continued)

CHART 1 (Figures 20 and 21)

Venting with One (1) 90° Elbow or Two (2) 90° Elbows

Total Vertical	Total Horizontal
(With Fire Box) V	H1 or H1 + H2
4.5' minimum	3' maximum
4.5' minimum	4' maximum
5' minimum	8' maximum
6' minimum	12' maximum
7' minimum	15' maximum
8' minimum	20' maximum
25' maximum vertical
20' maximum horizontal run

Figure 21 and Chart 1 list examples of possible venting systems using two (2) 90° elbows. V is listed as minimum vertical dimensions and H1 + H2 is listed as total of maximum horizontal dimensions. The maximum vertical and horizontal distances for two (2) 90° elbows as shown in Figure 21 are 20 feet.

Attention: Refer to Figure 10 for additional venting requirements.

10 3/8"

-30	37	5/8"			( 956mm)
				ELBOW
DVS	OF
CENTER			OUT
STRAIGHT

Figure 22

12 3/8"

	36	44		3/4"			114cm
							118cm
-
DVS	-42	46			3/4"
						ELBOW
DVS			OF
CENTER
					OUT
STRAIGHT

SEE CHART FOR PERMISSIBLE "H" AND "V" DIMENSIONS

NOTE: H1 AND H2 MUST BE ADDED TOGETHER TO USE CHART

Figure 21

Figure 23

Positioning the Fireplace

Determine the exact position of the appliance so the direct vent termination will be centered (if possible) between two (2) studs. This will avoid any extra framing. All vent kit pipes should be assembled on the unit after the unit is moved into the final position.

Page 14 13369-1-0203