DVS 30-2 installation instructions Important Safety Information

Page 3

IMPORTANT SAFETY INFORMATION

Before enclosing the Simpson Dura-Vent vent pipe assembly

operate the appliance to ensure it is venting properly.

DVS-36 OR DVS-42 IS A HEATING APPLIANCE WHEN HEATER BAFFLE IS INSTALLED, SEE PAGE 7

Do Not Operate This Appliance Without Glass Front Panel Installed.

• If this appliance is installed directly on carpeting,

Clothing or other flammable material should not be

 

tile or other combustible material other than wood

 

placed on or near the appliance.

 

flooring the appliance shall be installed on a metal

• Adequate accessibility clearances for servicing and

 

or wood panel extending the full width and depth of

 

 

proper operation.

 

the appliance.

 

 

• This appliance must not share or be connected to a

 

The base referred to above does not mean the

 

 

flue serving a separate solid-fuel burning appliance.

 

fireproof base as used on wood stoves. The protection

 

 

Keep the area around your appliance clear of

 

is for rugs that are extremely thick and light colored

 

tile.

 

combustible materials, gasoline and other flammable

• Children and adults should be alerted to the hazards

 

vapor and liquids.

Under no circumstances should any solid fuels (wood,

 

of high surface temperatures and should stay away

 

to avoid burns or clothing ignition.

 

coal, paper or cardboard etc.) be used in this appli-

• Young children should be carefully supervised when

 

ance.

The flow of combustion and ventilation air must not

 

they are in the same room as the appliance.

 

 

 

be obstructed in any way.

 

 

 

 

 

 

Due to high temperatures the appliance should be

DO keep the appliance area clear and free from

 

located out of traffic and away from furniture and

 

combustible material, gasoline and other flammable

 

draperies.

 

vapors and liquids.

• The glass front or any part removed for servicing

DO examine venting system periodically and replace

 

the appliance must be replaced prior to operating

 

damaged parts.

 

the appliance. Work should be done by a qualified

DO make a periodic visual check of pilot and

 

service person.

 

 

burners. Clean and replace damaged parts.

 

 

 

• Keep burner and control compartment clean.

CAUTION: The glass used in your fireplace is

 

 

• Vent cap is hot while fireplace is in operation.

 

tempered glass. If the glass is cracked or damaged

Installation and repair should be done by a

 

in any way, it should be replaced only with a

 

complete glass frame assembly from Empire. See

 

QUALIFIED SERVICE PERSON. The appliance

 

 

 

parts list on Page 40-42 for ordering.

 

should be inspected before use and at least annually

 

 

DO NOT use this fireplace if any part has been

 

by a qualified service person. More frequent

 

cleaning may be required due to excessive lint from

 

under water. Immediately call a qualified service

 

carpeting, bedding materials, etc. It is imperative

 

technician to inspect the heater and to replace any

 

that control compartments, burners and circulating

 

part of the control system and any gas control

 

air passageways of the appliance be kept clean.

 

which has been under water.

DO NOT put anything around the fireplace that

Any safety screen or guard removed for servicing

 

will obstruct the flow of ventilation air.

 

an appliance must be replaced prior to operating

 

 

 

the appliance.

 

 

 

 

13369-1-0203

Page 3

Image 3
Contents Installation Instructions Table of Contents Important Safety Information LP-GAS Warning Odor Safety Information for Users of LP-GASIntroduction Fireplace Dimensions Model DVS-30/DVS-36/DVS-42 SpecificationsHeater Baffle is Used on DVS-36 & DVS-42 only Fireplace Component InstallationClearances Figure Mantel Chart FigureClearances Locating FireplaceInstalling a New Main Gas Cock GAS SupplyChecking Manifold Pressures Example B InstallationVenting Fireplace Example aVent Runs Figures 14, 15, 16, 17 Three 3 basic types of installationsFraming Figure Finishing FigureInstallation Vertical Sidewall Application Positioning the Fireplace Cutting the Hole Figures 22 MAXVertical Sidewall Installations Termination ClearancesInformation on Various Venting Routes and Components Vent Clearances Installing Vent Components Figure Vent System IdentificationInner flue joints do not require any sealant Installing Support Brackets Figure Installing Firestops Figures 30, 31, 32DVS-30 Framing and Finishing DVS-30 Framing and Finishing DVS-36 & DVS-42 Framing and Finishing Installing Firestops Figures 35, 36, 37DVS-36 & DVS-42 Framing and Finishing Vertical Termination For All Models Installing the Vent System in a ChaseGlass Removal LOG PlacementReassembly and Resealing Vent Pipe System Vertical Through the Roof Applications FigureTOP View of LOG SET Glass ReplacementDVS-30 Placement of glowing embers DVS-36 and DVS-42 Placement of glowing embersStanding Pilot Operating Instructions Flame AppearanceMillivolt System Figures 48 Recommended Wire Gauges Standing Pilot Wiring Diagram What to do if YOU Smell GAS Standing Pilot Lighting InstructionsGlass soots Standing Pilot TroubleshootingFrequent pilot outage problem Pilot and main burner extinguish while in operationElectrical Connection Figure DVS-36 & DVS-42 Intermittent Pilot Wiring DiagramTo Turn OFF GAS to Appliance Checkout SpecificationsOperation Trial for IgnitionMain Burner Operation Safety LockoutARC Length Action Ignition System ChecksDVS-36 & DVS-42 Intermittent Pilot Troubleshooting RF Standing Pilot Operating Instructions RF Wiring Diagram RF Standing Pilot Lighting Instructions Please Note Maintenance and ServiceDVS-30 Parts List HOW to Order Repair Parts#41 Orifice NAT DVS-36 Parts ListDVS-42 Parts List Parts View Louvers Accessory PartsVariable Speed Blower Installation Instructions Blower Motor FBB1A Blower Installation Optional Single Speed Blower Installation InstructionsParts List Optional Fresh Air Intake Kit Figure Optional Fresh AIR Intake KIT DVFB-AK-30, FB-AK-2Example of Installation DVS-BL-30-2, DVS- BL-36-2, DVS-BL-42-2 Installing Optional Brick LinerParts List Brick Liner KIT