Enviro C-11102, C-11253 Methods for Resetting the Receiver, Method 1 From Outside the Cabinet

Maintenance And Service

CHANGING REMOTE HANDSET CODE & RESETTING RECEIVER:

A code is preset for the remote handset and receiver, but can be changed if required. If one or more

Sonnets are to be installed, confirm that the remote control signal codes are different for each unit.To change the code, complete the following:

1. Change DIP switch position (shown at the top of Figure 13).
2. Press and hold the receiver’s reset button (see Figure 14) until you hear
two (2) acoustic signals. After the second longer acoustic signal, release
	the reset button and within the
	subsequent 20 seconds, press the
	(down arrow) on the remote handset
	until you hear an additional long
	acoustic signal confirming the new
	code is set.	Figure 13: DIP Switch in
		Remote Handset Battery
Figure 14: Receiver with Reset Button.
		Compartment.

Figure 15: Resetting Receiver from Outside. Figure 16: Resetting Receiver from Inside.

Methods for Resetting the Receiver:

Method 1 - From Outside the Cabinet.

The access hole for the reset button is located on the left side of the unit 87/16” (214mm) back from the front edge of the cabinet. Place a small screwdiver through the hole in the cabinet side (refer to Figure

15)and depress the reset button. Method 2 - From Inside the Firebox.

Follow steps 1-4 in REMOVING VALVE COVER - MAINTENANCE AND SERVICE. Bend a paper clip to reach the reset button on the left side of the receiver (refer to Figure 16). Depress the reset button using the paper clip.

13