Enviro 50-1472, C-11253, C-11102 owner manual To be Installed by a Qualified Service Agency only

Page 14

Maintenance And Service

REMOVING VALVE COVER:

The valve cover can be removed to access the gas valve, the fan, wiring harness, or other components.

1.Remove the glass door as shown in the

MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.

2.Carefully remove the log set, ember material, and brick panels, refer to

SECONDARY INSTALLATION - BRICK PANEL INSTALLATION and SECONDARY INSTALLATION - LOG SET AND EMBER INSTALLATION.

3.Using a T-20 screwdriver remove the two

(2) screws that hold the burner tray in place (pointed out in Figure 17). Pick up the burner tray at the front (see Figure 18) then pull it out of the firebox.

4.Using a T-20 screwdriver remove the six

(6) screws that hold the valve cover in place (pointed out in Figure 19). Pick the valve cover up then out of the firebox (see Figure 20).

Figure 17: Screws Holding Burner Tray in Place.

Figure 18: Removing Burner Tray.

 

 

 

Figure 19: Screws Holding Valve Cover in Place.

 

Figure 20: Removing Valve Cover.

FUEL CONVERSION:

TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY

Please read and understand these instructions before installing.

Warning: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper or complete until the operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with the kit.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Consumer InstallerFor Your Safety Safety Precautions GeneralTable of Contents Codes And Approvals Vented GAS Fireplace Heater Sonnet BV/DV NG/LPGSpecifications DimensionsTrimmable Operating Instructions Lighting and Turning OFF InstructionsAutomatic Pilot Mode Setting the TimeSetting C/24 hour or F/12 hour Clock Adjustment of Flame HeightSetting the Temperature Changing the Mode of OperationMAN Mode Manual Flame Height Adjustment Setting the TimerRemote Control Instruction Component Sound & ReasonMaintenance And Service Pilot FlameRemote Handset ReceiverMethods for Resetting the Receiver Method 1 From Outside the CabinetTo be Installed by a Qualified Service Agency only Kit Parts List Conversion Kit InstallationIs pointing out then the valve is Initial Installation Mantle width and heightQualified Installers only Kit Contents Quantity Description Vent Kit InstallationInstall of Intake Air Plug Venting Fireplace Inserts Installation of Sonnet DV and BV DescriptionInstallation Instructions KIT ComponentsVertical Vent Cap Underside Electrical Requirements Fan Kit Installation Removing/Installing Back PanelFan Only Replacement Gas Line ConnectionTo Test Valve Pressures Labeled Gas ValveInstallation Options Proper Pilot FlameSecondary Installation InstallationAssembly Screw Hook Bracket To the TrimMinimum size of Large Installation RemovalHook Placements Ensure the Sonnet is turned off and allow the unit to coolEmpty firebox showing the ledges for the back logs Third Stage Log Set Installation Log Set and Ember Installation Never operate the fireplace with the glass door removedTrouble Shooting Problem Possible Cause SolutionPossible Cause Solution Valve’sBV only Parts List Reference Part Description Part NumberNumber Parts ListOption Description Parts Diagram Components Parts Diagram Options Warranty To the DealerWarranty Warranty Installation Data Sheet
Top Page Image Contents