Initial Installation
QUALIFIED INSTALLERS ONLY
OPTIONAL FAN KIT:
Tools Required: |
|
● 1⁄4” Socket or Driver or Flat Head Screwdriver | ● Utility Knife |
Kit Contents: |
|
Quantity | Description |
|
|
1 | Fan Kit Assembly (includes Back Cabinet |
| Panel, Fan, Mounting Bracket, Power Cord, |
|
|
1 | Wiring Harness |
|
|
1 | Temperature Sensor |
|
|
1 | Fan Control; 3 Position Switch |
|
|
Fan Kit Installation:
Please ensure that all components are supplied with this kit. If components are missing or have been damaged, contact your dealer, distributor or courier company before starting this installation
1.Use a flat head screwdriver, 1⁄4” socket, or a Torx
2.Hold the new back panel with the fan assembly close to the left side of the unit (see Figure 47).
3.Ensure the wiring harness is assembled according to Figure 45 & 47 and is attached to the fan.
4.Slide the fan switch and temperature sensor part of the wiring harness under the left of the firebox to the front
| of the unit. There are a couple of metal tabs on the lower |
| ||
| Figure 46: Removing/Installing Back Panel | |||
| left side of the cabinet that the wiring can be hooked | From Sonnet. | ||
| under. |
|
| |
|
|
| ||
5. Line up the new back panel with the |
|
| ||
| screw holes in the back and install |
|
| |
| the screws for the back cover. |
|
| |
6. | Pull the right end of the control |
|
| |
| panel forward; it will pivot out (see |
|
| |
| Figure 12). |
|
| |
7. | Slide the temperature sensor into |
|
| |
| the holding tabs below the left end |
|
| |
| of the burner behind the control |
|
| |
| panel. |
|
| |
8. | Using a utility knife cut out the |
|
| |
| rectangle on the control panel |
|
| |
| between the two (2) fan symbols. |
|
| |
| Figure 47: Installing Fan onto Back Panel. | |||
9. Make note of the order the | ||||
|
| |||
connectors are in on the three (3) position switch and remove them. Slide the switch through the front of the hole that was just cut out and reattach the connectors to the switch.
10. Close the control panel.
26