INSTALLATION
LOG SET INSTALLATION
Read the instructions below carefully and refer to the diagrams. If the logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.
The gas log kit contains the following:
a)Rear Log
b)Left Side Front Log
c)Right Side Front Log
d)Center Front Log
e) Embers |
A)
B)
C)
1) | Shut off the gas supply. |
2) | Lift off the Cast Top and remove the Glass Front (see manual). |
3) | Carefully remove the logs from the box and unwrap them. The logs |
| are fragile, handle with care - do not force into position. |
4) | Place the rear log on the 2 rear log locating pins on the rear of the |
| burner with the fl at side to the back. |
5)Place the 2 front logs on the front log locating pins. Ensure the back of both logs rest against the tabs.
B)
Left Front Log
NOTE: This is |
|
a rear view. | B) |
|
Tabs
A)
Right Front Log
A)
The Front Right Log front edges should be placed parallel against the front edge of the burner.
C)
B)
C)
NOTE: This is
a rear view.
C)
Tabs
Hampton® | 31 |