Hampton Direct H25-NG1, H25-LP1 Planning Your venting Installation, Optional Components

INSTALLATION

RESIDENTIAL AND MANUFACTURED HOMES / MOBILE HOMES

MINIMUM HORIZONTAL TERMINATION INSTALLATIONS

Planning Your venting Installation

See the "Exterior Vent Terminatal Locations" sectionforrequirements.TheH25isapproved for a minimum horizontal termination with the FPI Riser Vent Kit. See the diagram for minimum and maximum pipe lengths.

You will require the following components with your new Hampton® Rear Vent Direct Vent Free- standing Gas Stove. Please review your product to make sure you have everything you need. In the event that you are missing any part, contact your dealer. Decorative brass

or chrome trim kits are available from Simpson Dura-Vent for their wall thimbles, as well as a square wall thimble cover.

When planning your installation, it will be nec-
essary to select the proper length of vent pipe
for your particular requirements. Determine the				Horizontal
minimum clearance to combustibles from the
				Terminal
rear of the unit to the wall. It is also important to
				Part# 640-530/P
note the wall thickness. Before cutting the vent
hole through the wall ensure that ALL vent and				Vinyl Siding
termination clearances (see the "Exterior Vent				Standoff (Optional)
Terminal locations" section) will be met.				Part #946-205
				Wall Thimble
*Ifthisisanoutsidecorner,theminimumdistance		Decorative		(required for
between the vent and the outside corner is 6"	Adapter	Wall Trim	combustible walls)
				Part # 946-202
(15cm). See "F" on the diagram in the "Exterior	Part #946-219/P	Part #640-545/P
Vent Terminal Locations" section.	(required)
		Pipe Length (max. 18")
		Part (6-5/8" Dia)
		(4" Dia.)
	Note: Thesearetheminimumpiecesrequired.
	Other parts may be required for your
	particular installation.

NOTE: Ensure compliance with the outside vent terminal location before cutting hole as both dimensions must be met.

Minimum components for a Horizontal Installation:

640-944 Horizontal Termination Kit which includes:

1		6-5/8" Dia. x 18" Black Pipe
1		4" Dia. x 18" Aluminum Vent
1	946-202	Wall Penetration Heat Shield (Wall Thimble) (2 pcs)
1	640-530/P	Riser Vent Terminal
1	640-545/P	Decorative Wall Trim (Black)
1	948-128	Tube Mill-Pac
946-219/P 1	Adapter	Screws
Optional Components:
946-204	45o Elbow - 6-5/8" Black pipe
	and 4" Aluminum Vent
946-205	Vinyl Siding Shield for Riser Vent
	Terminal
946-208/P	Vent Guard
940	Square Wall Thimble Cover*

981Snorkel Termination (36")*

982Snorkel Termination (14")*

942	Wall Penetration
	Heat Shield*

* Simpson Dura-Vent components

20 Hampton® H25-1 Direct Vent Freestanding Gas Stove