Hampton Direct H25-NG1, H25-LP1 Removing Valve, Installing Valve Assembly, Screws

MAINTENANCE

3)Unclip the black and white wires from the fan motor.

4)Remove the 2 bolts holding the fan to the rear base. Disconnect the green ground wire from the right side of the fan as soon as you can reach it.

Replacing the Fan:

Reverse the above steps (1 - 4). Make sure the fan wires and the ground wire are reat-

6)Disconnect piezo wire.

7)Lift off the Cast Top and lift out the front door.

8) Carefully remove the logs and embers.

9)Remove burner by removing the 2 screws on each side and then lifting the burner tray out.

Screws

Note: Use a magnetic type screwdriver if possible.

12)To remove the valve, remove the 4 screws (2 per bracket) that hold the valve to the valve bracket assembly.

13)To replace the burner tray assembly, simply reverse these instructions.

To remove valve from valve assembly, continue.

14)	Remove two (2) thermopile wires.
15)	Remove thermocouple with a 9 mm (metric)
	wrench.
16)	Remove pilot nut with an 11 mm wrench.
17)	Remove valve to orifi ce nut with a 13/16"
	wrench.
18)	Remove inlet pipe with pipe wrench. Note
	orientation of 90o elbow.
19)	Remove two (2) phillips head M5 screws on
	each side of the valve.

REMOVING VALVE

If your valve requires maintenance or replace- ment, use the following instructions:

Note: Alwayscloseoffthegassupplybefore removing the valve.

1)If optional fan is installed, disconnect power source to stove.

2)Remove access panel.

3)Disconnect gas line to stove.

4)Disconnect 3/8" NPT pipe from 90o elbow on valve or fl ex connector.

5)Disconnect the two (2) switch wires from valve.

10)Remove all 6 screws holding the burner tray assembly in place.

11)Carefully lift the burner tray assembly out.

20) Remove valve and remove gas out 90o brass

fi tting. Note orientation of fi tting.

INSTALLING

VALVE ASSEMBLY

1)To install a new valve assembly, reverse instructions for removing valve. See as- sembly steps 1-12.

2)Check for leaks and manifold pressure. See Gas Pressure Test instructions.

3)To reinstall valve, reverse instructions for removing valve assembly, steps 13-19.

40 Hampton® H25-1 Direct Vent Freestanding Gas Stove