Regency U32-LP4, U32-NG4 Optional Double Screen Doors, Standard Flush Door, Optional Flush Trim

Page 12

INSTALLATION

Diagram 2

Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd spring. See diagram 3.

Diagram 4

OPTIONAL DOUBLE

SCREEN DOORS

1)Pull out the top louver.

2)Center the screen door and hook over the fl ush door.

Diagram 5

Diagram 5.

11)Push the Regency® logo plate into the

STANDARD

FLUSH DOOR

The standard flush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1. Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Diagram 2.

Diagram 1a

Diagram 1b

Diagram 3

To remove the fl ush door, reverse the above steps.

NOTE: The chain must rest on TOP of the gas inlet pipe never under it.

OPTIONAL

FLUSH TRIM

Attach 2 round magnets to the back of the top trim piece and the other 2 to the bottom trim piece, then attach trim to the top and bottom of Flush door.

3)Open the screen door(s) and secure the screen door to the fl ush door front with 2 clips on the bottom left and right side.

Clip locations

Clip installed on right side.

FLUSH LOUVERS

1)The top louver is held in place by friction fi t, if the louver needs to be adjusted; bend the bracket out as shown in the diagram.

12

U32-4 FPI Direct Vent Gas Insert

Image 12
Contents U32 Gas Insert FPI GAS Insert To the NEW OwnerTable of Contents Safety Label Requirements MA Code CO DetectorInstallation Installation Checklist Minimum Fireplace DimensionsManufactured Mobile Home Additional Requirements Materials RequiredFlue Liner Installation VentingGAS Connection GAS Pipe Pressure Testing GAS Insert Aeration SystemOptional Brick Panel Natural Gas PropaneLOG SET Installation Gas log kit contains the followingRegency Faceplate Trim Installation Rear burnerOptional Double Screen Doors Standard Flush DoorOptional Flush Trim Flush LouversBAY Louvers Optional BAY DoorOptional BAY Trim Removing Bay DoorConversion KIT #514-969 from NG to LP For P36D-1 / P36-4 OnlyInstallation of the DC Sparker Ground Wire from Kit Full Screen Doors Hinge Hampton Cast Faceplate Installation Ensure that Top and sides are AlignedHampton Cast Grill Installation U31 onlyKensington Front Installation Left SideKensington Panel Door Installation Glass Door Sub-Frame HookOptional Remote Control Thermostat Wire TableKensington Optional Wall ThermostatWiring Diagrams Electrical Grounding InstructionsFor Propane Units and Units Equipped with DC Spark Boxes Operating Instructions Maintenance Instructions Copy of Lighting Instruction PlateMaintenance FAN Maintenance Bay Glass RemovalValve Replacement Entrire assembly outInstall a new gasket and reinstall the valve assembly Shut off the gas supplyParts List Main AssemblyBurner Assembly & LOG SET Bay Door Flush DoorFaceplate Assembly 400-917402-918 Complete Faceplate Set Hampton Cast Faceplate Assembly 187 189 188 194 203 201 207 195 205U32-4 FPI Direct Vent Gas Insert U32-4 FPI Direct Vent Gas Insert U32-4 FPI Direct Vent Gas Insert Warranty Warranty Limited LifetimeInstaller Please complete the following information