INSTALLATION
2)Install the Spring Hinges on the left and right side of the bottom of the Firebox using 2
screws per hinge.
3) Place the Bottom Louver near the hinge. Flip hinge over the Bottom Louver and secure using 3 screws.
Hinge
Location
SIT Extension knobs for Bay Front only.
BAY LOUVERS
1)Install top louver by sliding the two bracket clips into the brackets located on top of the bay door. See below.The fitted louver leaves a small gap between faceplate bottom and louver top.
Bottom Louver
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the flush front. The standard fl ush door and glass must remain on the unit. Hook the top of the bay door over the fl ush door fl ange and swing the bottom against the bottom fl ange of the fl ush door. Press down on the Bay Bottom bracket and push in until it clips behind the bottom of
Removing Bay Door
To remove the Bay Door & the Flush Front together, pull the hook from the slot in the bottomdoorbracketundertheunit(seeStandard Flush Door instructions above). Then pull the Bay Door and Flush door out and lift off of the fl ange at the top of the unit.
Note: If any maintenance etc. must be done in the firebox, first remove the Bay louvers and door.
2)Install bottom louver by sliding the two bracket clips into the brackets located underneath the bay door. Secure with 1 screw into each Bottom Louver Mounting Bracket as per diagram below. Use the bottom hole in the bracket.
the fl ush front.
OPTIONAL BAY TRIM
Attach the 4 supplied magnets, each to the back of the top and bottom trim pieces (space out evenly) and attach trim to the top and bot- tom of Bay door.
3) Slide the valve extension knobs onto the valveknobs.Matcheachextensionknobwith the corresponding valve knob. Extension knobs are for Bay Front installations only.
13 |