INSTALLATION
CONVERSION KIT #514-969 FROM NG TO LP
for
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG Conversion Kit and one DC Sparker Kit.
Conversion Kit Contains:
For | 6) Pull off the pilot cap to expose the pilot |
| orifice. |
5)Remove the 2 screws holding the Burner Assembly to the firebox base. Push the Burner Assembly to the left and lift out.
Qty. | Part # | Description |
1 | Burner Orifice #52 | |
1 | 5/32" Allen Key | |
1 | Decal "Converted | |
|
| to LPG" |
1 | Red "LPG" label | |
1 | LPG Injector | |
|
| (Pilot Orifice) |
1 | Instruction Sheet | |
DC Sparker Kit Contains: | ||
Qty. | Part # | Description |
1 | Bracket DC Sparker | |
1 | Bracket DC Sparker | |
1 | Washer #8 External Star | |
1 | Nut | |
1
2
0.500 in.
1
2
Black Oxide
1 | Spark Generator Battery | |
|
| Holder |
1
1 | Battery Size AA | |
|
| Energizer En91 |
2 | Clip Wire Holder |
1
Remove the 2 screws, push Burner Assembly
to the left and lift out.
For U32-4 Only:
5a) Remove the grate by removing the screws on each side of the grate.
Remove the 2 screws
holding the grate in position.
5b) Remove the Burner Tray by removing the screws on each side of the tray. Push the tray to the left and lift up.
7)Unscrew the pilot orifice with the allen key; then replace with the LPG pilot orifice and the pilot cap, provided in the kit.
8)Remove burner orifice with a 1/2" wrench. Use another wrench to hold on to the elbow behind the orifice. Discard orifice.
Installation of LPG
Conversion Kit:
1)Shut off the gas supply.
2)Remove the louvers (and bay door if it is installed).
3)Open the flush door and remove the door.
4)Remove the logs and embers (if used).
Burner Orifi ce
Remove the 2 screws,
push Burner Tray to the left, and lift off.
14 |