Regency U32-NG4, U32-LP4 installation manual Kensington Front Installation, Left Side

Page 21

INSTALLATION

THE KENSINGTON®

FRONT INSTALLATION

IMPORTANT: Please use the gloves provided when handling the Kensington® Front to avoid fi ngerprints.

1)Place the Kensington® Front up against the unit , but do not secure. Make the following wire connections:

Connect the fan switch wires by taking the black and red wires with the male ends (in the grey harness) and connect them with the wire connectors from the fan speed control.

Connect the ON/OFF switch wires by taking the black and red wires with the female ends and connect them to the ON/OFF switch.

Tuck the wires into the faceplate to keep them away from the insert using the clip provided. Attach the clip to the rear of the faceplate to ensure that the wires do not touch the side of the unit.

The power cord should be run behind the faceplate panel.

2)Mount the Kensington® Front onto the fi rebox by securing in place using 4 screws, 2 per side.

Kensington®

Front

Left Side

ScrewsShown

3)Slide the Tabs on the Blanking Plate into the slots located on Front and secure using 2 screws.

Blanking Plate Tabs

Kensington®

Front

Blanking

Plate

Screw

Screw

U32-4 FPI Direct Vent Gas Insert

21

Image 21
Contents U32 Gas Insert To the NEW Owner FPI GAS InsertTable of Contents Safety Label MA Code CO Detector RequirementsInstallation Minimum Fireplace Dimensions Installation ChecklistManufactured Mobile Home Additional Requirements Materials RequiredFlue Liner Installation VentingGAS Connection GAS Insert Aeration System GAS Pipe Pressure TestingOptional Brick Panel Natural Gas PropaneGas log kit contains the following LOG SET InstallationRear burner Regency Faceplate Trim InstallationStandard Flush Door Optional Double Screen DoorsOptional Flush Trim Flush LouversOptional BAY Door BAY LouversOptional BAY Trim Removing Bay DoorFor P36D-1 / P36-4 Only Conversion KIT #514-969 from NG to LPInstallation of the DC Sparker Ground Wire from Kit Full Screen Doors Hinge Ensure that Top and sides are Aligned Hampton Cast Faceplate InstallationU31 only Hampton Cast Grill InstallationLeft Side Kensington Front InstallationGlass Door Sub-Frame Hook Kensington Panel Door InstallationThermostat Wire Table Optional Remote ControlKensington Optional Wall ThermostatElectrical Grounding Instructions Wiring DiagramsFor Propane Units and Units Equipped with DC Spark Boxes Operating Instructions Copy of Lighting Instruction Plate Maintenance InstructionsMaintenance Bay Glass Removal FAN MaintenanceEntrire assembly out Valve ReplacementInstall a new gasket and reinstall the valve assembly Shut off the gas supplyMain Assembly Parts ListBurner Assembly & LOG SET Flush Door Bay DoorFaceplate Assembly 400-917402-918 Complete Faceplate Set 187 189 188 194 203 201 207 195 205 Hampton Cast Faceplate AssemblyU32-4 FPI Direct Vent Gas Insert U32-4 FPI Direct Vent Gas Insert U32-4 FPI Direct Vent Gas Insert Warranty Limited Lifetime WarrantyInstaller Please complete the following information