Lopi Yankee Bay Pellet Insert manual 4Safety Precautions

Page 4

4Safety Precautions

Do not operate the heater if you smell smoke coming from the heater. Turn the POWER switch to "OFF", monitor your heater, and call your dealer .

Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or 'freshen up' a fire in this heater. Keep all such liquids well away from the heater while it is in use.

Do not unplug the heater if you suspect a malfunction. Turn the MODE SWITCH to "OFF" and monitor the heater (see the “Maintenance” section for details).

Never try to repair or replace any part of the heater unless instructions are given in this manual. All other work should be done by a trained technician.

The viewing door and ashpan must be closed and latched during operation.

Never block free airflow through the open vents of the unit

Do not operate the heater if the flame becomes dark & sooty of if the firepot overfills with pellets. Turn the MODE SWITCH to "OFF" and and monitor the heater (see the “Maintenance” section for details).

Ok

Contact your local building officials to obtain a permit and information on any installation restrictions or inspection requirements in your area. Notify your insurance company of this heater as well.

The exhaust system must be completely airtight and properly installed. The pellet vent joints must be sealed with RTV 500o F. (260o C.) silicone sealant.

This unit must be properly installed to prevent the possibility of a house fire. The instructions must be strictly adhered to. Do not use makeshift methods or compromise in the installation.

Your heater requires periodic maintenance and cleaning (see "Maintaining Your Heater"). Failure to maintain your heater may lead to smoke spillage in your home.

Allow the heater to cool before carrying out any maintenance or cleaning. Ashes must be disposed in a metal container with a tight lid and placed on a non-combustible surface well away from the home or structure.

This heater is designed and approved for pelletized wood fuel only. Any other type of fuel burned in this heater will void the warranty and safety listing (see page 6 for details).

Travis Industries

4 0 5 0 5 0 9

1 0 0 - 0 1 1 4 5

Image 4 Contents
Yankee Bay Pellet Insert Introduction Important Information 2IntroductionTravis Industries 5 0 5 0 0 0 1 1 4 Table of Contents 4Safety Precautions Safety Precautions Mobile Home6Specifications Installation7 8Installation Hopper Extension Set-upInstallation9 Re-install the hopper walls following the directions below0Installation Installation1 Venting the Pellet StoveMobile Home Requirements 2InstallationOutside Air used for combustion Baffle Installation Restrictor AdjustmentNot Enough Air Too Much Air4Installation Surround Panel & Circuit Board InstallationInstallation into a Masonry Fireplace Hint6Installation Installation into a Factory Built MetalSafety Notice Operation1Location of Controls Starting the Heater for the First TimeLoading Pellets 8OperationTwo Modes of Operation Manual Mode To Adjust the HeatTo Start To Shut DownTo Adjust Room Temperature or Start the Stove Auto Mode0Operation Adjusting the Fan Speed Operation22Operation Maintenance2 Daily Maintenance whenever using the heaterInspect the Burn Make Sure Pellets are Not Piling UpCleaning the Firepot 4MaintenanceCheck Firepot for Clinkers Bi-Weekly Maintenance or every 10 bags of pellets Clean the Heat Exchange TubesCleaning the Optional Plated Surfaces Vacuum Hopper6Maintenance Opening The DoorClean the Glass Check Baffles, Ashbox, Ashpan, Dispose Ash If Necessary8Maintenance Sweep Ash Into AshpanYearly Maintenance or every two tons 0Maintenance Clean the Vent make sure the heater and vent is coolDoor Seal Maintenance3Door Alignment 2Maintenance Adjusting the Door Hinge and LatchReplacement Parts Check for Air Leaks Around the Door, Glass, and Ashpan4Normal Operating Sounds Safety Label Serial NoLimited 7 Year Warranty Years 1 & 2 Coverage Parts & LaborOptional Equipment ThermostatRemote Thermostat 8Optional EquipmentOptional Log ZC Kit 9 9 2 0 0 1 4 0Index