Lopi Yankee Bay Pellet Insert manual Maintenance2, Daily Maintenance whenever using the heater

Page 23

Maintenance2 3

Daily Maintenance (whenever using the heater)

Inspect the Burn

When burning on high, the flames should be bright orange with embers jumping from the firepot.

NOTE: the optimal restrictor position will vary over time as soot builds up inside the exhaust system. See "Restrictor Adjustment" for details.

Make Sure Pellets are Not

Piling Up

If the pellets pile up over the burn pot, turn the mode switch to "OFF".

The most likely causes are:

• Restrictor needs adjustment (see “Restrictor Adjustment” in the installation section of this manual)

• The door, glass, or ashpan is open or has an air leak

• The firepot requires cleaning

• The exhaust system requires cleaning

Travis Industries

4 0 5 0 5 0 9

1 0 0 - 0 1 1 4 5

Image 23

Contents

Yankee Bay Pellet Insert Travis Industries 5 0 5 0 0 0 1 1 4 2IntroductionIntroduction Important Information Table of Contents 4Safety Precautions Mobile Home Safety Precautions6Specifications Installation7 Hopper Extension Set-up 8InstallationRe-install the hopper walls following the directions below Installation90Installation Venting the Pellet Stove Installation1Outside Air used for combustion 2InstallationMobile Home Requirements Too Much Air Baffle InstallationRestrictor Adjustment Not Enough AirSurround Panel & Circuit Board Installation 4InstallationHint Installation into a Masonry FireplaceInstallation into a Factory Built Metal 6InstallationStarting the Heater for the First Time Safety NoticeOperation1 Location of ControlsTwo Modes of Operation 8OperationLoading Pellets To Shut Down Manual Mode To Adjust the Heat To Start0Operation Auto ModeTo Adjust Room Temperature or Start the Stove Operation2 Adjusting the Fan Speed2Operation Make Sure Pellets are Not Piling Up Maintenance2Daily Maintenance whenever using the heater Inspect the BurnCheck Firepot for Clinkers 4MaintenanceCleaning the Firepot Vacuum Hopper Bi-Weekly Maintenance or every 10 bags of pelletsClean the Heat Exchange Tubes Cleaning the Optional Plated SurfacesOpening The Door 6MaintenanceCheck Baffles, Ashbox, Ashpan, Dispose Ash If Necessary Clean the GlassSweep Ash Into Ashpan 8MaintenanceYearly Maintenance or every two tons Clean the Vent make sure the heater and vent is cool 0MaintenanceDoor Alignment Maintenance3Door Seal Adjusting the Door Hinge and Latch 2MaintenanceCheck for Air Leaks Around the Door, Glass, and Ashpan Replacement Parts4Normal Operating Sounds Serial No Safety LabelYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyThermostat Optional EquipmentOptional Log 8Optional EquipmentRemote Thermostat ZC Kit 9 9 2 0 0 1 4 0Index