Lopi Yankee Bay Pellet Insert manual 8Maintenance, Sweep Ash Into Ashpan

Page 28

2 8Maintenance

Bi-Weekly Maintenance (or every 10 bags of pellets) - Continued

Sweep Ash Into Ashpan

HINT:

The more often you clean out the flyash, the more efficient your heater will burn.

NOTE:

Remove the ashbox prior to conducting the service below.

 

WARNING:

 

The firebox becomes very hot during operation. Let the stove cool completely before conducting service.

aSwing the side ash trap door up.

Ash Trap

Door

bLift it up and away from the firebox. Repeat for the opposite side.

c Lift the firepot out of its holder.

d Slide the ash pan trap door forward to expose the ash

 

dumps (the door can be removed and cleaned if necessary)

Firepot

 

Ash Pan

Trap Door

e

Brush all flyash into the ash dumps, including

f

Replace the ash trap doors and firepot.

the flyash inside the firepot holder.

Slide the ash pan trap door forward.

 

 

HINT:

To empty the ashpan, see the instructions on the previous page.

Travis Industries

4 0 5 0 5 0 9

1 0 0 - 0 1 1 4 5

Page 27 Page 29
Image 28
Page 27 Page 29
Contents
Yankee Bay Pellet Insert Introduction Important Information 2IntroductionTravis Industries 5 0 5 0 0 0 1 1 4 Table of Contents 4Safety Precautions Safety Precautions Mobile Home6Specifications Installation7 8Installation Hopper Extension Set-upInstallation9 Re-install the hopper walls following the directions below0Installation Installation1 Venting the Pellet StoveMobile Home Requirements 2InstallationOutside Air used for combustion Baffle Installation Restrictor AdjustmentNot Enough Air Too Much Air4Installation Surround Panel & Circuit Board InstallationInstallation into a Masonry Fireplace Hint6Installation Installation into a Factory Built MetalSafety Notice Operation1Location of Controls Starting the Heater for the First TimeLoading Pellets 8OperationTwo Modes of Operation Manual Mode To Adjust the HeatTo Start To Shut DownTo Adjust Room Temperature or Start the Stove Auto Mode0Operation Adjusting the Fan Speed Operation22Operation Maintenance2 Daily Maintenance whenever using the heaterInspect the Burn Make Sure Pellets are Not Piling Up Cleaning the Firepot 4Maintenance Check Firepot for Clinkers Bi-Weekly Maintenance or every 10 bags of pellets Clean the Heat Exchange TubesCleaning the Optional Plated Surfaces Vacuum Hopper6Maintenance Opening The DoorClean the Glass Check Baffles, Ashbox, Ashpan, Dispose Ash If Necessary8Maintenance Sweep Ash Into AshpanYearly Maintenance or every two tons 0Maintenance Clean the Vent make sure the heater and vent is coolDoor Seal Maintenance3Door Alignment 2Maintenance Adjusting the Door Hinge and LatchReplacement Parts Check for Air Leaks Around the Door, Glass, and Ashpan4Normal Operating Sounds Safety Label Serial NoLimited 7 Year Warranty Years 1 & 2 Coverage Parts & LaborOptional Equipment ThermostatRemote Thermostat 8Optional EquipmentOptional Log ZC Kit 9 9 2 0 0 1 4 0Index
Top Page Image Contents