Nilfisk-ALTO SR 1700 2WD B manuel dutilisation Instructions for USE, Machine USE

USER MANUAL

Joystick

(See Fig. J)

The joystick is used for the following functions (all of the functions must be carried out with the safety switch pressed):

–Hopper lifting (1, Fig. J);

–Filter shaker (2, Fig. J);

–Skirt opening (3, Fig. J);

–Side broom lowering (4, Fig. J);

–Side broom rotation (5, Fig. J);

–Main broom lowering (6, Fig. J);

–Main broom rotation (7, Fig. J);

–Skirt closing (8, Fig. J);

–Hopper lowering (9, Fig. J);

–Main broom rotation (10, Fig. J);

–Main broom lowering (11, Fig. J);

–Suction fan stop (12, Fig. J);

–Main broom rotation stop (13, Fig. J);

–Side broom rotation stop (14, Fig. J);

–Main broom lifting (15, Fig. J);

–Side broom lifting (16, Fig. J);

–Safety switch.

INSTRUCTIONS FOR USE

Start

NOTE

Machines with the EC marking are provided with safety devices should the operator leave the driver’s seat.

The machine cannot be started unless the operator is sitting in position.

–Before starting the machine, make sure the parking brake (5, Fig. H) is engaged.

–Connect the battery cable socket with the machine cable plug.

–Be sure of the perfect connection.

–Insert the ignition key in the ignition switch.

–Turn the ignition key clockwise to the first position. The battery charge indicator light should be on.

–Turn the ignition key clockwise until the end of stroke. When the motor is on, release the ignition key which will automatically return to the first position.

NOTE

Before trying to start the machine again, turn the ignition key back to “0” position.

As soon as the machine has been started, check the battery charge and oil pressure warning lights are off.

Switching off

Turn the ignition key counterclockwise to “0” position and then remove it. Pull the parking brake lever.

Hand pump (See Fig. K)

WARNING!

Lift the cab manually.

–Install the lever (1, Fig. K) in the pump.

–Make sure that the slider is in a position that allows the cab to be lifted. Pump to lift the cab.

–To lower the cab, change the position of the slider.

NOTE

After lowering the cab, maintain the slider in the middle position.

MACHINE USE

Waste collection

–Operate the fan by pressing the push-button.

–Main broom lowering, fan and main broom start, skirt opening: press the push-button and release. The main broom lowers and starts rotating. The suction fan starts working at the same time.

–Main broom and right side (left side optional) broom lowering and start: press the push-button, the brooms lower and start rotating. Hold the push-button pressed until the ideal adhesion for the type of cleaning to be carried out is reached.

–In case of wet surface, turn off the fan.

–The operating speed recommended for the sweeper, adjusted by means of the pedal, ranges from 1 to 8 km/h, depending on the amount of waste to be collected.

During the collection phase, the waste should be compacted in order to maximize the load collected:

–Stop the sweeper

–Close the skirt

–Re-open the skirt and re-start the sweeper

33014816(1)2005-07 A 9