Integra DTR-8.4 instruction manual Tape Mode, Rewind/FF / buttons, Reverse Play button

DTR-8.4_En.book Page 20 Thursday, October 16, 2003 11:09 AM

Remote Controller—Continued

Tape Mode

Tape mode is used to control an Integra/Onkyo cassette

recorder connected to the DTR-8.4 via . To select

Tape mode, press the scroll wheel. “AMP” appears on the display.

Note:

While neither the [Input] button nor [Mode] button is illuminated, the scroll wheel changes the input source and remote controller mode simultaneously (e.g., set the input source and mode to “TAPE.”)

Scroll wheel

E

AMode button

This button is used with the scroll wheel to select the remote controller modes. Press the scroll wheel until “AMP” appears on the display.

BPrevious/Next [ ]/[] buttons

The Previous [ ] button is used to select the pre- vious track. During playback it selects the begin- ning of the current track. The Next [ ] button is used to select the next track.

The Previous/Next [ ]/[ ] buttons make not work properly with some cassette tapes depending on how they were recorded.

CRewind/FF [ ]/[ ] buttons

The Rewind [ ] button is used to start rewind. The FF [ ] button is used to start fast forward.

DRec [] button

This button is used to start tape recording.

ELight button

This button is used to turn on or off the remote con- troller’s illuminated buttons.

FInput button

		This button is used to select the input source. Press
		this button first, and then roll the scroll wheel until
		“TAPE” appears on the display.
		G VOL button
		This button is used to set the volume of the
		DTR-8.4.
		H Muting button
A	F	This button is used to mute the DTR-8.4. This func-
		tion can be set only with the remote controller.

I Play [ ] button

This button is used to start tape playback.

	G
2	8
	9
3
	J
4	K

JStop [] button

This button is used to stop tape playback.

KReverse Play [] button

This button is used to start reverse playback.

20