Integra DTR-8.4 Advanced Setup, Audio Adjust Functions, Assigning the a & B 12V Trigger Outputs

DTR-8.4_En.book Page 68 Thursday, October 16, 2003 11:09 AM

Advanced Setup—Continued

■f. D.F. Mono

With this setting you can specify the listening mode to be used when a mono digital audio signal is played (DVD, etc).

Only listening modes that can be used with mono PCM, Dolby Digital, or DTS can be selected.

•The Last Valid option means that the listening mode selected last will be used.

Notes:

•The b, c, d, e, and f settings are available only when an digital audio input is assigned to the selected input source.

•You can select other listening modes during playback (see page 59), however, the listening mode assigned here will be resumed after the DTR-8.4 has been set to Standby.

Assigning the A & B 12V Trigger Outputs

This section explains how to assign input sources to the 12V TRIGGER OUT A and B outputs.

1	Press the [Input] button, and then
	roll the scroll wheel to select the
	input source you want to assign.

5

6

The 12V Trigger Setup menu appears.

Advanced Menu

2.Input Setup Input:DVD

2-7.12V Trigger Setup

Input:DVD

a.Trigger A	:On
b.Trigger B	:Off
	Quit:SETUP

Use the Up/Down []/[ ] but- tons to select a. Trigger A or b. Trigger B, and use the Left/Right []/[ ] buttons to select:

On: Trigger output active while

input source selected. Off: Trigger output not active

while input source selected.

Press the [Setup] button. The setup menu closes.

2	Press the scroll wheel, and then
	press the [Setup] button.
	The main menu appears onscreen.

3 Use the Up/Down []/[ ] but- tons to select “2. Input Setup,” and then press the [Enter] but- ton.

The Input Setup menu appears.

4 Use the Up/Down []/[ ] but- tons to select 7. 12V Trigger Setup, and then press the [Enter] button.

Audio Adjust Functions

This section explains the audio and listening mode set- tings you can use to tailor the sound as you like.

1	Press the scroll wheel, and then
	press the [Setup] button.
	The main menu appears onscreen.

2	Use the Up/Down [ ]/[ ] but-
	tons to select “3. Audio Adjust,”

and then press the [Enter] but- ton.

The Audio Adjust menu appears.

68