Integra DTR-8.4 instruction manual Running Macros, Naming Macros

DTR-8.4_En.book Page 95 Thursday, October 16, 2003 11:09 AM

Using the Remote Controller with Other Components—Continued

Running Macros

Programmed macros can be run as follows.

1	Press the [Macro] button.
2	Roll the scroll wheel to select the
	macro’s number, and then press
	the scroll wheel.
	The actions in the macro are performed
	in the order in which they were pro-
	grammed.

Naming Macros

You can name your macros as follows. Names may con- tain of up to five characters.

1	Press and hold the [Custom] but-
	ton for more than three seconds.
	The remote controller enters Custom
	mode.

2	Roll the scroll wheel to select
	“MACRO,” and then press the
	scroll wheel.

5

6

Macro #1 selected

1st character

Roll the scroll wheel to select a character, and then press the scroll wheel to set it.

The following characters are available.

0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N_O P Q R S T U V W X Y Z + – = < > _ / * space

Macro #1 selected

1st character set

Repeat step 5 until you’ve entered all 5 characters.

The previous menu reappears.

If the name you are entering consists of less than five characters, enter spaces at the end to make it up to five.

3	Roll the scroll wheel to select
	“NAME,” and then press the
	scroll wheel.

4	Roll the scroll wheel to select the
	number of the macro that you
	want to name, and then press the
	scroll wheel.

95