Integra DTR-8.4 instruction manual Crossover Frequency

DTR-8.4_En.book Page 42 Thursday, October 16, 2003 11:09 AM

Basic Setup—Continued

7

8

Use the Up/Down []/[ ] but- tons to select “d. Surround,” and then use the Left/Right []/[ ] buttons to select:

Small: Select if the surround left and right speakers are small.

Large: Select if the surround left and right speakers are large.

None: Select if no surround left and right speakers are connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

Use the Up/Down []/[ ] but- tons to select “e. Surr Back,” and then use the Left/Right []/[ ] buttons to select:

Small: Select if the surround back left and right speakers are small.

Large: Select if the surround back left and right speakers are large.

None: Select if no surround back left and right speakers are con- nected.

Notes:

•If the Surround setting in step 7 is set to None, this setting cannot be selected.

•If the Surround setting in step 7 is set to Small, this setting cannot be set to Large.

•If the Surr Back/Zone2 setting is set to Zone 2, this setting cannot be selected (see page 86).

Continue with step 9 in the right col- umn.

Crossover Frequency

9	Use the Up/Down [		]/[	] but-
	tons to select “f. Crossover,” and
	then use the Left/Right [			]/[ ]
	buttons to select a crossover fre-
	quency.
	Choose a crossover frequency suitable
	for your setup. If you’re using a sub-
	woofer, choose a crossover frequency
	based on the diameter of your front
	speakers. If you’re not using a sub-
	woofer, use the diameter of any speaker
	that you specified as Small.
	If you’re using THX-certified speakers,
	select 80 (THX).
		Speaker cone	Crossover
		diameter	frequency
		Over 12 in.	40Hz
		(30 cm)
		8 to 12 in.	60Hz
		(20–30 cm)
		6-1/2 to 8 in.	80Hz (THX)
		(16–20 cm)
		5-1/4 to 6-1/2 in.	100Hz
		(13–16 cm)
		3-1/2 to 5-1/4 in.	120Hz
		(9–13 cm)
		Under 3-1/2 in.	150Hz
		(9 cm)
10	Press the [Setup] button.
	The setup menu closes.

Notes:

•If the crossover frequency is set to a low value, and the program material doesn’t contain any sounds that are below that frequency, accordingly, the subwoofer will not output much sound.

•This procedure can also be performed by using the

DTR-8.4’s [Setup] button, []/[ ]/[]/[ ] but- tons, and [Enter] button.

42