Integra DTR-8.4 2Network Settings, Press the scroll wheel, and then Press the Setup button

DTR-8.4_En.book Page 82 Thursday, October 16, 2003 11:09 AM

Net-Tune—Continued

2Network Settings 3

This section explains how to manually configure the

DTR-8.4’s network settings.

If your router’s DHCP server is enabled, by default the DTR-8.4 is set use DHCP to configure itself automati- cally (i.e., the DHCP/AUTO IP setting is On), so you don’t need to change any of the settings on the

“5. Network Setup” menu. If your router’s DHCP server is disabled, for example, you’re using static IP addresses, you’ll need to configure these settings yourself. A knowledge of Ethernet networking is essential.

What’s DHCP/AutoIP?

DHCP (Dynamic Host Configuration Protocol) and Auto

IP (Automatic IP Addressing) are services used by rout- 4 ers, computers, the DTR-8.4, and other devices to auto- matically configure themselves on the network.

What’s DNS?

The DNS (Domain Name System) translates domain names into IP addresses. For example, when you enter a domain name such as www.integrahometheater.com in your Web browser, before accessing the site, your browser uses DNS to translate this into an IP address, in this case 63.148.251.142.

5

1, 2

1

3, 4, 6

3–6

2, 7

6

1	Press the [Input] button, and then
	roll the scroll wheel to select
	either “IRD” or “MSRV.”

2	Press the scroll wheel, and then		7
	press the [Setup] button.
	If the Basic menu appears, use the
	Down [	] button to select Advanced
	Menu, and press the [Enter] button to
	display the Advanced menu.

Use the Up/Down []/[ ] but- tons to select “5. Network Setup,” and then press the [Enter] but- ton.

The Network Setup menu appears.

5.Network Setup

1.IP Address 2.Proxy Setup 3.MAC Address 4.Client Setup

→Save Settings

[ENTER]Quit:[SETUP]

Use the Up/Down []/[ ] but- tons to select the menu items, and then press the [Enter] but- ton.

The IP Address menu is shown here.

Use the Up/Down []/[ ] but- tons to select the settings, and use the Left/Right []/[ ] but- tons to set them.

To enter an IP address, select the set- ting, and then press the [Enter] button. The []/[ ]/[]/[ ] buttons can then be used to enter numbers. Press the [Enter] button again to set the number.

The settings are explained below.

When you’ve completed the set- tings on any menu, press the [Return] button to return to the “5. Network Setup” menu, use the Up/Down []/[ ] buttons to select “Save Settings,” and then press [Enter].

Don’t turn off the DTR-8.4 while the settings are being saved (about 2 sec- onds), otherwise they’ll be lost.

Press the [Setup] button.

The setup menu closes.

82