Integra DTR-8.4 instruction manual Component Video Setup, Ton, Video Setup menu appears

DTR-8.4_En.book Page 47 Thursday, October 16, 2003 11:09 AM

Basic Setup—Continued

Component Video Setup

This section explains how to assign the component video inputs to input sources. You only need to change this set- ting if you connect a video component to a component video input other than the default assignment listed in the following table, or if you want to output composite video or S-Video sources from the component video output. There are no other reasons to change these assignments.

Input source	Analog audio	Component
	input (fixed)	video inputs
DVD	DVD	INPUT1
VIDEO 1	VIDEO 1	INPUT2
VIDEO 2	VIDEO 2	INPUT2
VIDEO 3	VIDEO 3	INPUT2
VIDEO 4	VIDEO 4	INPUT2
VIDEO 5	VIDEO 5	INPUT2
TAPE	TAPE	Last Valid
TUNER	TUNER	Last Valid
PHONO	PHONO	Last Valid
CD	CD	Last Valid
NET AUDIO	NET AUDIO	Last Valid

1	Press the [Input] button, and then
	roll the scroll wheel to select the
	input source you want to assign.

2	Press the scroll wheel, and then
	press the [Setup] button.
	The main menu appears onscreen.

3 Use the Up/Down []/[ ] but- tons to select “2. Input Setup,” and then press the [Enter] but- ton.

The Input Setup menu appears.

4	Use the Up/Down [	]/[	] but-
	tons to select “3. Video Setup,”
	and then press the [Enter] but-
	ton.
	The Video Setup menu appears.
	Advanced Menu
	2.Input Setup
	Input:DVD
	2-3.Video Setup
	Input:DVD
	a.Video
	:DVD
	b.Component Video
	:INPUT1
	Quit:SETUP
5	Use the Up/Down [	]/[	] but-

tons to select “b. Component Video,” and then use the Left/ Right []/[ ] buttons to select:

INPUT1: Select if the video compo- nent is connected to COM-

PONENT VIDEO INPUT 1.

INPUT2: Select if the video compo- nent is connected to COM-

PONENT VIDEO INPUT 2.

VIDEO: Select this to output com- posite and S-Video sources from the COM-

PONENT VIDEO OUT- PUT.

Last Valid: Select this for audio-only

components.

None: Select this if you want no video to be output when the input source is selected.

6	Press the [Setup] button.
	The setup menu closes.

Notes:

•If you select Last Valid, the video source remains the same when you select another input source. For exam- ple, if you set the VIDEO 1 input source to Last Valid, then select the DVD input source, then select the VIDEO 1 input source, you can watch a DVD while listening to the audio from the component connected to the VIDEO 1 audio inputs.

•This procedure can also be performed by using the

input selector buttons, [Setup] button, [ ]/[ ]/[ ]/ [ ] buttons, and [Enter] button.

47