Integra Basic Operation, Muting the DTR-8.4 remote controller only, Using Headphones

DTR-8.4_En.book Page 52 Thursday, October 16, 2003 11:09 AM

Basic Operation—Continued

Scroll wheel

Dimmer Sleep

Muting

Muting the DTR-8.4 (remote controller only)

With this function you can temporarily mute the output of the DTR-8.4.

Press the scroll wheel, and then press the remote controller’s [Muting] button.

The output is muted and the MUTING indicator flashes on the display.

To unmute the DTR-8.4, press the remote controller’s [Muting] but- ton again.

Note:

•The Mute function is cancelled when the volume is adjusted or the DTR-8.4 is set to Standby.

Using the Sleep Timer (remote controller only)

With the sleep timer you can set the DTR-8.4 so that it automatically turns off after a specified period.

Press the scroll wheel, and then press the [Sleep] button repeat- edly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set. The specified sleep time appears on the display, then the previous display reappears.

To check the remaining sleep time,

press the [Sleep] button. Note that if you press the [Sleep] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

To cancel the sleep timer, press the [Sleep] button repeatedly until the SLEEP indicator disappears.

Note:

•Any component in Zone 2 connected to the DTR-8.4’s 12V TRIGGER OUT will also turn off when the spec- ified sleep time expires.

Setting the Display Brightness

You can adjust the brightness of the DTR-8.4’s display as follows.

Press the scroll wheel, and then press the [Dimmer] button to select: dim, dimmer, or normal brightness.

Note:

•This procedure can also be performed by using the DTR-8.4’s [Dimmer] button.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch phone plug) to the DTR-8.4’s PHONES jack for private listening.

Standby/On

Standby

Phones	Direct/		Audio	Rec (RED)	DVD	Video 1
	Pure Audio			Zone 2 (GRN)
	Pure Audio	U psampling	Selector
						VCR 1
	Phones	Zone 2 Level	Rec Out	Zone 2	Off	Stereo Surround

Notes:

•Turn down the volume before connecting your head- phones.

•While a pair of headphones is connected to the PHONES jack, no sound is output by the speakers. (Any speakers in Zone 2 continue working.)

•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Mono, Stereo, Direct, or Pure Audio. When you disconnect the headphones, the previous listening mode is resumed.

•Only the Stereo, Direct, Pure Audio, and Mono listen- ing modes can be used with headphones. (Available listening modes also depends on the currently selected input source.)

•When you use the multichannel inputs, only the front left and right channels can be heard in the headphones.

52