Wayne-Dalton 3982 installation instructions Important Notice

Page 1
www.wayne-dalton.com

Wayne-Dalton Corp.

P.O. Box 67 Mt. Hope, OH 44660

(888) 827-3667Installation Instructions and Owner’s Manual

www.wayne-dalton.com

Model 3982 idrive™ Extension Spring Kit.

Use these instructions to install the extension spring kit with idrive™ Models: 3660-372/ 3661-372/ 3662-372/ 3760-372

Covered under one or more of the following U.S. patents: D413,579;D466,141; D472,568; D472,910;D473,573; D473,574; D474,215; D505,393; D517,580; 5,929,580; 6,078,249; 6,145,570; 6,164,014; 6,253,824; 6,263,947; 6,325,134; 6,326,751; 6,326,754; 6,401,792; 6,561,255; 6,561,256; 6,568,454; 6,588,156; 6,605,910; 6,667,591; 6,739,372; 6,845,804; 6,851,465; 6,873,127; 6,880,609; 6,903,650; 7,053,571; 7,061,197; 7,075,256; 7,109,677; 7,123,128; 7,143,804; 7,173,389; 7,173,514; 7,173,516; 7,183,732; 7,190,266; 7,193,502; 7,207,142; 7,211,975. other U.S. and foreign patents pending

Important Notice!

Use these instructions instead of the manual included with your idrive™. Read the enclosed instructions carefully before installing/operating this garage door opener. Pay close attention to all warning labels and notes. This manual should be attached to the wall in close proximity to the garage door opener.

© Copyright 2007 Wayne-Dalton Corp.

Part No. 306436

Rev1 7/6/2007

Image 1
Contents Model 3982 idrive Extension Spring Kit Important NoticeSystem Requirements Table of ContentsFCC and IC Statement FCC Regulatory InformationINSTALLATION AND USE INSTALLATION AND USEHardware Kit: 3982 idrive Extension Spring Kit idrive Hardware Kit idrive Package ContentsTools Needed Available Accessories: For idriveExtension idrive Installation idrive Retro-fitInstallationStep 1: Extension Spring Relief Step 2: Remove Front SheaveStep 4A: Track Width Conformation Step 4: Flag Bracket InstallationNOTE: In some instances there shown in stepStep 6 Bottom Bracket Lifting Cables Step 5: Cable Drum InstallationNOTE Do not remove shrink wrap from cable drums until instructed to do soStep 8 Extension Spring Counterbalance Step 7: Drum Wrap Installationwrapped oppositely on the drum Step 10 Lower the Door Step 9: Safety Cable InstallationWARNING TO AVOID SEVERE IN JURY DO NOT PLACE FINGERS OR HANDNOTE Hold the opener by the main Step 11: idrive Opener/Torque Tube Assemblybody. Do not hold by the motor NOTE: Do not force the opener ontoStep 13: Secure idrive Opener tion be pilot drilled using 1/8” drill bit Step 14: Disconnect InstallationNOTE: It is recommended that 1/4” lag screw loca and Owner’s ManualStep 15: Wall Station Installation Pre-OperationInstallationJumper Settings: Opener Switch Settings Light FixtureStep 16 Multi-Opener/LightFixture Programming CEILING MOUNTING Step 17: Light Fixture Installationpower back on at fuse box Light Fixture Installation ContinuedWALL MOUNTING NOTE: If wires must be lengthened or spliced into Step 18: Photoelectric Safety Sensor Installationnectors Installation Continued Photoelectric Safety SensorCONVENIENT POWER OUTLET Step 19: Power Connection Standard WiringLIGHT FIXTURE POWER OUTLET RECEPTACLE #6 X 7/8 WOOD SCREWS POWER CORD FEMALE END OPENERStep 20 Power Connection Permanent Wiring Option Step 21 Securing the Opener Step 22: Photoelectric Safety Sensor AlignmentWall Station Programming Changing the wall station’s security codeMOTOR OPERATED POSITION Step 24 Install RoutineUP/DOWN BUTTON PROFILE BUTTON Step 26: Lock Arm Installation Step 25: Detent Adjustment if requiredStep 27: Custom Settings Step 29: Contact Obstruction Test Step 28 Photoelectric Obstruction Sensor TestChange and Programming Step 30: Transmitter Security CodeCHANGING THE TRANSMITTER’S SECURITY CODE TRANSMITTER PROGRAMMINGStep 31: Programming HomeLink to idrive Teaching Power Unitper Step PROGRAMMING Training HomeLink Unit8.SAVE THESE INSTRUCTIONS Important Safety InstructionsOperation Transmitter OperationWall Station Operation service person immediatelyMOTOR DOWN POSITION DOOR LOCKED Manual Door Operation Emergency DisconnectDISCONNECTED, MOTOR UP POSITION Monthly Maintenance MaintenanceBattery replacement NOTE: Dispose of dead batteries properlySYMPTOM TroubleshootingPROBABLE CAUSE CORRECTIVE ACTIONLock Arm Troubleshooting Troubleshooting continuedSYMPTOM SYMPTOMLIFETIME LIMITED WARRANTY Wayne-DaltonCustomer ServiceQuestions?? For quick answers and helpful advise, call