Wayne-Dalton 3982 Transmitter Security Code, Change and Programming, Transmitter Programming

Step 30: Transmitter Security Code

Change and Programming

NOTE: The user must change the transmitter’s security code before using the transmitter.

This code sequence is only necessary the first time the transmitter is used.

Overview: When changing the transmitter’s security code, the user will have to hold the large button down for approximately 10 seconds, then release the button momentarily, and finally hold the button down again for approximately 5 seconds.

CHANGING THE TRANSMITTER’S SECURITY CODE:

1.Press and hold the large transmitter button for approxi- mately 10 seconds until the transmitter’s LED begins to blink rapidly. Once the LED starts blinking, release the large transmitter button; the LED will turn off.

2.Press and hold the large transmitter button again (LED will light) for approximately 5 seconds. After ap- proximately 5 seconds the LED will begin to blink on and off. Release the large button. The transmitter’s LED will blink on and off three times indicating a successful security code change. The transmitter is now ready to be programmed to the opener.

TRANSMITTER PROGRAMMING:

MOTOR IN UP POSITION

OPENER

RED PROGRAM

BUTTON

LARGE

BUTTON

HANDLE IN MANUAL

OPERATED POSITION

To program transmitter:

1.Place the emergency disconnect handle in the manual door operated position. This is for safety reasons.

2.On the front cover of the opener, press and release the red program button; the opener will beep once, indi- cating activation of the program mode. The opener will remain in program mode for 30 seconds.

3.Press and hold the desired transmitter button until; the opener beeps once. The transmitter is now pro- grammed.

4.Return the emergency disconnect handle to motor operated position.

NOTE: No beeping response of the opener during the transmitter programming indicates a programming fail- ure. Repeat programming 1-4.

NOTE: Programming failure can occur during the transmitter programming if the remote control is too close to the opener during the programming sequence. Perform the programming with a minimum distance of six feet between the remote control and the opener.

NOTE: The first transmitter command, after programming, will only move the door through a six-inch up/down cycle. Normal door operation will occur on the second usage of the transmitter.

NOTE: The opener can be activated by up to six remote control devices (including wall station, transmitter, and keyless entry devices.) If a seventh control is programmed, the first of the programmed controls will be overridden and will no longer activate the opener.

CAUTION: For safety reasons, manually disconnect the door from opener using the emergency discon-

nect handle prior to erasing remote controls. To clear programming of all remote control devices, press and hold the opener’s program button for approximately ten seconds. When the opener beeps three times, all remote controls are erased.

28