Wayne-Dalton 3982 Multi-Opener/LightFixture Programming, Switch Settings Light Fixture

Step 16: Multi-Opener/Light Fixture Programming

NOTE: Skip this step if installing only one idrive™ opener.

Switch Settings: Light Fixture

If installing more than one opener in the same garage, the light fixtures can be set to function only with a selected opener. Leaving the light fixture as is from the factory may cause all light fixtures to light when any one of the openers are activated. The opener jumpers and light fixture switches need to be matched to allow for the opener

to activate a specific light fixture. To adjust switch		-A-	-B-	-C-	-D-
location on light fixture, slide switches on top of light
fixture housing.
LIGHT FIXTURE
	SWITCHES	-A-
		SWITCH 1 (OFF)			-C-
		SWITCH 2 (OFF)			SWITCH 1 (ON)
		(FACTORY			SWITCH 2 (ON)
		SETTING)
		-B-			-D-
Jumper Settings: Opener
					SWITCH 1 (OFF)
On the right side of the opener, insert jumper(s) provided		SWITCH 1 (ON)
					SWITCH 2 (ON)
		SWITCH 2 (OFF)
in the hardware pack, to match the switch setting of the
light fixture.
-A-	-B-	-C-			-D-

NO JUMPERS

FOR PINS 1 & 2

Jumper Settings

Light Fixture		Opener
Detail		Detail
-A-	=	-A-
-B-	=	-B-
-C-	=	-C-
-D-	=	-D-

PIN 1 PINS 1 & 2 PIN 2

OPENER

When the light fixture switches and the opener jumpers are matched, the light fixture will respond to its matched opener.

16