I. Blower Installation
KIT CONTENTS:
1 - Blower Mounted in Housing
2 - Speed Control Knob
3 - Pal Nut
4 - Ceramic Snap Disk
5 - Speed Control (Rheostat)
6 - Wire Harness (attached to Blower)
7 - 12 Screws
8 - 12 inch Glass Tape
9 - 1 Zip Tie
10 - Bracket #1
11 - Snap Disc Bracket
TOOLS REQUIRED: Short #2 Philips screwdriver; 11/16" wrench.
1011
Figure 8.12 Open and inspect contents of the blower kit. The contents of the kit are listed above. If any of the parts are missing or damaged, please contact your dealer for replacements. NOTE: Not all parts will be used for this install.
Figure 8.13 Lift off the appliance top and place it on a flat surface, with the porcelain side up to prevent damage. Remove the back shield by removing the two screws along the top of the shield.
Place the blower on the floor behind the appliance and route the ends of the wiring harness through the rubber grommet on the underside.
Figure 8.14 Holding the blower in place, attach it to the appliance with four of the screws provided.
SNAP DISC | SNAP DISC |
| BRACKET |
SPADE
TERMINALS
Figure 8.15 Install the snap disc. A snap disc bracket is located in the appliance's component bag. Bend the two spade teminals on the snap disc from a horizontal to a vertical position. Insert the snap disc through the hole in the snap disc bracket and attach the two white wires from the wiring harness to the snap disc.
NOTE: The mounting flange is on top of the bracket.
Page 34 | Heat & Glo · Tiara Petite B · | August 1, 2008 |