J. Warming Shelves Installation
KIT CONTENTS: (2) Warming shelves, (2) brackets, and (4) 1/4 in. Phillip head screws.
TOOLS NEEDED: Phillips head screwdriver.
Figure 8.20 Remove warming shelves and hardware from packaging. Install leveling bolt to each warming shelf.
Figure 8.21 Install warming shelf bracket loosely to each warming shelf using the bolt provided.
Figure 8.23 Align bracket to firebox and gently tighten the screw to hold it in place.
Reassemble the appliance.
K. Glass Replacement
Turn the appliance OFF and let it cool down before replacing the glass. Lift off the appliance top and place it on a flat surface with the porcelain side up to prevent damage.
Remove the appliance front by sliding it upwards in the grooves being careful not to chip the porcelain. Lay the front face up on a flat surface.
Unhook the latch now exposed on top of the appliance. Pull the top of the glass frame toward you and lift it out of the retainer along the bottom of the firebox.
Replacement is the reverse of the removal.
Figure 8.22 Gently lift cast top off of unit and set aside.
Install warming shelf to unit gently aligning the shelf with the tabs that are in place on the side of the unit. Use the leveling bolt in the located in the center of the warming shelf to adjust the shelf to it's desired position.
CAUTION
Handle glass assembly with care.
•Inspect the gasket to ensure it is undamaged.
•Inspect the glass for cracks, chips or scratches.
•Do NOT strike, slam or scratch glass.
•Do NOT operate appliance with glass door removed, cracked, broken or scratched.
•Replace glass assembly as a complete assembly.
August 1, 2008 | Heat & Glo · Tiara Petite B · | Page 37 |