8 Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the firebox.
B. Accessories
Install approved accessories per instructions included with accessories. Refer to Section 12 for appropriate accesso- ries.
WARNING
Shock or fire risk.
Use ONLY optional accessories approved for this appliance.
•Using
• Using
•Only Hearth & Home Technologies approved accessories may be used safely.
Figure 8.2 Uninstall the existing crown by removing the four screws on the back side of the door. Retain the screws.
Figure 8.3 Use a flat-head screwdriver to pry the black crown free on the right side. Remove the crown and discard.
C. Door Crown Installation
Stationary latches
Spring latches
Figure 8.1 Open lower access panel. Pull out and unhook the two spring latches on the bottom of the appliance that secure the door.
Rotate the door forward approximately 1-1/2 in. (38mm). Holding the ashlip, lift the door up off of the stationary latches and away from the appliance.
Figure 8.4 Carefully align the left side of the crown into place, and wrap it across the face of door, finally snapping it into place on the right hand side. Reinsert and tighten the screws previously removed.
Use a soft cloth and a window cleaning solution to clean all fingerprint oils from the gold or nickel surface of crown PRIOR to lighting the appliance.
|
|
|
|
Page 28 | 10/08 | ||