6 Gas Information
A. Fuel Conversions
Before making gas connections ensure that the appliance being installed is compatible with the available gas type.
Any natural or propane gas conversions necessary to meet the appliance and locality needs must be made by a quali- fied technician using Hearth & Home Technologies specified and approved parts.
1. Converting to LP Gas
NOTE: Gas conversions should only be performed by a qualified service person, and/or where required by state and local codes, licensed installer/service technician. In the Commonwealth of Massachusetts, installation must be performed by a licensed plumber or gas fitter.
KIT CONTENTS: Replacement orifice; replacement pilot injector; and valve regulator.
TOOLS REQUIRED: Ratchet with 7/16 in. socket and 2 in.
-4 in. extension: power drill (a 90° handle is helpful); #2 Phillips bit; 5/32 in. allen wrench; 5/8 in. open end wrench.
2 nuts holding burner pan
Figure 6.1 Remove right and left twigs and right and left rear logs from the burner pan, if installed. Remove the 2 nuts that secure the burner pan to the burner support with the ratchet and socket.
Figure 6.2 Lift burner up and out of the firebox opening.
3 screws
Figure 6.3 Remove the three screws on the front of the burner support. Set screws aside.
Burner support screws locations
Figure 6.4 Slide the burner support to the left to access the orifice.
|
|
|
|
Page 22 | 10/08 | ||