Panasonic How to Register a Handset to a Base Station

Special Features

Re-registering the Handset Handset & Base Unit

If “No link to base. Move closer to base, try again.” is displayed even when using the handset near the base unit, the handset may have lost communication with the base unit. You need to re-register the handset to the base unit.

•Make sure the base unit is not being used.

•Have both handsets and base unit nearby during registration.

•Follow steps 1–3 listed below. You have about 1 minute to complete them.

•Confirm the extension number of the handset which has lost the communication by placing the handset on the base unit or charger.

If you re-register the handset using the other handset’s extension number, the other handset will not function.

1Base unit: Press and hold [LOCATOR/ INTERCOM] until a beep sounds.

•The CHARGE indicator flashes.

2Base unit: Press the extension number [1] ( ) or [2] ( ) of the handset which has lost the communication.

3Handset: Press and hold [FLASH/CALL WAIT] until “Handset Registering” is displayed.

•When registration is complete, a beep sounds from the handset and the display shows the number.

•Wait for 20 seconds after registration is complete while the handset establishes communication with the base unit.

Handset Registering

Ex. Extension number 1

Handset [1] Registered

•If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try again from step 1.

•You can stop registration by pressing [OFF] on the handset, and pressing [LOCATOR/INTERCOM] on the base unit.

56