Panasonic KX-TG2361JX - page 75

75

Troubleshooting

Useful Information

You cannot make an intercom/

outside call.

• Your handset is in remote operation mode

(p. 60). Exit by pressing [OFF].

• The handset you called is too far from the

base unit.

• If the handset or base unit is in use, you may

not be able to make a call. Try again later.

• You cannot make an outside call when the

Dial Lock is turned on. To cancel the mode,

see page 55.

You cannot redial. • If the last number dialed was more than

48 digits long, the number will not be

redialed correctly.

• You cannot redial when the Dial Lock is

turned on. To cancel the mode, see page55.

The handset does not display

the caller’s phone number.

• You need to subscribe to Caller ID.

• Other telephone equipment may be

interfering with your phone. Disconnect it

and try again.

• Other electrical appliances connected to the

same outlet may be interfering with Caller

ID.

• Telephone line noise may be affecting Caller

ID.

• The caller requested not to send his/her

Caller ID information (p.30).

• If a call is being transferred to you, the

Caller ID information will not be displayed.

• If a (separate) Caller ID box is connected

between the unit and the telephone wall

jack, disconnect the Caller ID box or plug

the unit directly into the wall jack.

The handset and/or base unit

does not announce the

displayed caller’s name.

• The handset and/or base unit ringer

volumes are turned off. Set to high, medium,

or low (p. 17, 18).

• The Talking Caller ID feature is turned off.

Turn it on (p.32).

The handset and/or base unit

does not announce the

displayed caller’s name

properly.

• Name pronunciation may vary.

• The handset and/or base unit will announce

each letter of abbreviations, such as “Co.”

and “Inc.”.

• Caller ID supports names of up to 15 letters.

If the caller’s name has more than 15 letters,

the name will not be announced correctly.

Problem Cause & Remedy

Contents

Main Page For Best Performance Battery Charge Base Unit Location/Noise Raise the antenna. Contents Contents Location of Controls Location of Controls B Charger unit Location of Controls Handset soft keys 1 Handset navigator key Base unit display Installation Connections Charger unit Installation Installing the Battery in the Handset To replace the battery: Battery Charge Place the handsets on the base unit and charger. Charge for 6 hours before initial use. Installation Recharge Recharge battery Battery information Battery replacement: Programmable Settings Programming Guidelines 5 2 How to select a function item from the menu Function Menu Table Main menu Sub-menu ISub-menu II Date and Time 2 3 Date and time Dialing Mode 4 5 Set dial mode Line Mode 4 3 5 Set line mode Auto talk Ringer Volume Handset ringer volume 3 4 Ringer volume Base unit ringer volume Ringer Tone 3 Handset ringer tone Ringer tone Page LCD Contrast 3 4 Preparing the Answering System Greeting Message LCD contrast Page Pre-recorded greeting Callers Recording Time 5 4 Recording time Number of Rings 4 5 Number of rings Recording Mode 4 3 5 Recording mode Message alert Making Calls Using the Handset Page To put a call on hold To return to the call, press [C] or [s]. Voice Enhancer Technology To turn this feature on, press(VE)during a conversation. Backlit LCD display/Lighted handset keypad Using the Base Unit Answering Calls Caller ID Service How Caller ID information is displayed *Private name display 15552223333 TINA ROBINSON Caller ID Service TINA ROBINSON Caller ID Service To turn Talking Caller ID on or off 5 4 Talk Caller ID Set base unit Talk Caller ID Using the Caller List Viewing the Caller List 2 3 What , means Calling Back from the Caller List ] to enter the Caller List. ]. 3 Editing the Callers Phone Number 3 4 5 6 Storing Caller Information in the Phone Book CINDY TURNE ], or [ ] to enter the Caller List. ] or 3 Erasing Caller Information To erase a specific caller To erase all entries 2 3 Phone Book Storing Names and Numbers 5 2 3 T m Dialing from the Phone Book 3 4 Index table Chain Dial 2 1 3 Editing an Item in the Phone Book Jane Walke 3 5 4 Erasing an Item in the Phone Book Copy phone book Copy 1 item To copy all of the items in your phone book to another handset 2 3 Copy phone book Copy all items Intercom Making Intercom Calls Intercom Answering Intercom Calls During an intercom call: 1 2 Intercom Voice Paging Transferring a Call From the to the From the to the 1 2 Transferring a Call Conference Calls Call Share Special Features Temporary Tone Dialing (For Rotary or Pulse Service Users) Muting Your Conversation Press Mute. 9P15556667777 (For PBX Line/Long Distance Calls) 5 4 FLASH Button Incoming call. Set base unit Incoming call. Key Tone 3 2 4 Key tone Dial lock To cancel the Dial Lock 5 2 Dial lock @@@@ Re-registering the Handset 1 2 3 Handset & Base Unit Automatic Answering Operation Setting the Unit to Answer Calls Press [ANSWER ON] to turn on the Answering System. 2 3 4 Automatic Answering Operation Monitoring Incoming Calls Listening to Messages Using the Base Unit To play back messages Press [MESSAGE]. Listening to Messages Message play Listening to Messages Base Unit Handset During playback Erasing Messages Recording a Memo Message Remote Operation from a Touch Tone Phone Summary of remote operation 4 Remote Code u Remote Operation from a Touch Tone Phone Voic e Me nu Remote Operation from a Touch Tone Phone Direct Remote Operation Direct commands To turn on the Answering System: Skipping the greeting Page Wall Mounting 1 2 3 4 Wall Mounting Direct Commands Direct Commands If the Following Appears on Your Display... If the Following Appears on Your Display... Troubleshooting Page Page General Safety Instructions Safety Instructions Specifications