LG Electronics LS-Q076BBG, LS-Q096BBG Connecting The Cable Between Indoor Unit and Outdoor Unit

Page 30

3.Connecting The Cable Between Indoor Unit and Outdoor Unit

1)Connect the cable to the Indoor unit.

•Connect the cable to the indoor unit by connecting the wires to the terminals on the control board in dividually according to the outdoor unit connection. (Ensure that the color of the wires of the outdoor unit and the terminal No. are the same as those of the indoor unit.)

The earth wire should be longer than the common wires.

CAUTION

•When installing, refer to the circuit diagram on the Control Box of Indoor Unit.

•When installing, refer to the wiring diagram on the Control Cover Inside Outdoor Unit.

CAUTION

•The above circuit diagram is subject to change with- out notice.

•Be sure to connect wires according to the wiring dia- gram.

•Connect the wires firmly, so that not to be pulled out easily.

•Connect the wires according to color codes by refer- ring the wiring diagram.

CAUTION

If a power plug is not to be used, provide a circuit breaker between power source and the unit as shown below.

The power cord connected to the "A" unit should be complied with the following specifications

(Type "B" approved by HAR or SAA).

							(mm2)
	NORMAL			Grade
	CROSS
		5k~9K	12k~14k	18k	24k~28k	30k, 32k	36k, 38k
	-SECTIONAL
		0.75	1.0	1.5	2.5	2.5	5.5
	AREA
	Unit(A)	Indoor	Indoor	Indoor	Indoor	Outdoor	Outdoor

Cable Type(B) H05VV-F H05VV-F H05VV-F H05VV-F H05RN-F H05RN-F

The power connecting cable connected to the indoor and outdoor unit should be complied with the following specifications

(Type "B" approved by HAR or SAA).

Main power source

Air		Circuit Breaker
Conditioner		Use a circuit
		breaker or time
		breaker or time
		delay fuse.

					(mm2)
	NORMAL		Grade
	CROSS
		5k~9k	12k~14k	18k	24k~28k
	-SECTIONAL
		0.75	1.0	1.5	2.5
	AREA

Cable Type(B) H07RN-F H07RN-F H07RN-F H07RN-F

(mm2)

	NORMAL CROSS	Grade

		30k, 32k	36k, 38k
	-SECTIONAL AREA	30k, 32k	36k, 38k
	-SECTIONAL AREA	0.75	0.75
		0.75	0.75

	Cable Type(B)	H07RN-F	H07RN-F

NORMAL CROSS-SECTIONAL AREA 0.75mm2

-30-

Image 30

Contents Room Air Conditioner Contents Details of LG Model Name2002 Code Type Code of Model MeaningDetails of LG Model Name2003~ MeaningFunctions Indoor UnitRemote Control Room, Temperature Checking PLASMAOptional Setting the Time or Timer Timer SelectionAirflow Direction Control Air Circulation Product References Model NameUnit 1Ø, 220V, 60Hz Dimensions All ModelsOutdoor Unit 9k Heat Pump Refrigeration Cycle Diagram Cooling Only ModelsWiring Diagram LS-Q096ABL, LS-Q096AEL LS-H096QNA0, LS-H096QNA0Cooling Mode Operation Healthy Dehumidification ModeOperation Details Heating Mode Operation Defrost ControlFuzzy Operation C/O Model Fuzzy Operation H/P ModelFuzzy Operation for Cooling Fuzzy Operation for Dehumidification On-Timer OperationAirflow Speed Selection Fuzzy Operation for HeatingSleep Timer Operation Off-Timer OperationOff-Timer ↔ On-Timer Operation Chaos Swing ModeAir Cleaner Operation Jet Cool Mode Operation C/O ModelJet Cool Mode Operation H/P Model Forced OperationRemote Control Operation Mode Protection of the evaporator pipe from frostingBuzzer Sounding Operation Heating Model Display FunctionSelf-diagnosis Function Cooling ModelInstallation Selection of the best locationPiping length and elevation How to fix installation plate Drill a hole in the wallFlaring work Indoor unit installation Connection of piping IndoorFor right rear piping Wrap the insulation material around the connecting portion Tighten the flare nut with a wrenchInsert the connecting cable into the indoor unit Tape the drain hose and the connecting cableConnection of the pipes-Outdoor Align the center of the pipings and sufficientlyTighten the flare nut by hand Connecting The Cable Between Indoor Unit and Outdoor Unit Connect the cable to the Indoor unitConnect the cable to the outdoor unit To remove the front panel from the indoor unit Checking the drainageForm the piping To check the drainageSettlement of outdoor unit Prepare remote controlPump Down Procedure Evaluation of the performanceName and Function-Remote Control OperationON/OFF Timer Buttons Disassembly of the parts Indoor unit To remove the Grille from the ChassisTo remove the Discharge Grille When repair, do not damage the Caution labelTo remove the Control Box To remove the EvaporatorTo remove the Motor Cover To remove the Cross-Flow FanWay, 3-way Valve Way Valve Liquid SideProcedure Check for gas leakagePurge the air from the system Air purging of the charge hose Set the 2-way valve to the closed positionRe-air purging Balance refrigerant of the 2-way, 3-way valves Gas leakageEvacuation All amount of refrigerant leakedAfter Evacuation Connect the charge hose to the charging cylinderPurge the air from the charge hose Cycle Troubleshooting Guide Trouble analysisElectronic Parts Troubleshooting Guide Product is not operate with the remote control Compressor/Outdoor Fan are unable to drive When indoor Fan does not operate When Vertical Louver does not operate When Heating does not operate Way RelayPage Electronic Control Device Main P.W.B Assembly DC Part TOP View Bottom View TOP View 6871A20194 TOP View 6871A30009 TOP View6871A20227 TOP View 6871A20390 TOP View 6871A20391 TOP ViewSchematic Diagram LED Type HVB Typeplasma Heat Pump Model LED Type Heat Pump Model HVB Type Exploded View and Replacement Parts List Parts ListIndoor LS-Q076ABL LS-Q076BBG LS-Q076BELLS-Q096ABL LS-Q096BBG CABLE, Flat CABLE, Falt Cover ASSEMBLY,MOTOR LS-Q082AAL LS-C082QMA0 LS-C082QNA0 LS-C096QGL0 LS-C096QLA0 LS-C096QNA0 LS-H096QGL1 W0CZZ Parts ListOutdoor 552202 567502 561410 554160 447910 550140 430410 552203-2 TUBE,CAPILLARY Bend Compressor Base ASSEMBLY,OUTDOOR Tube ASSY,CAPILLARY LS-C082QMA0 LS-C082QNAO LS-C096QGL0 3041AR2415K April