
RESET BUTTON
HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (NOT ON ALL MODELS)
Used to set the desired horizontal airflow direction.
Used to start or stop the plasma-purification function.
PLASMA(OPTIONAL)
Used prior to resetting time or after replacing batteries.
16 2nd F Button
Used prior to using modes printed in blue at the bottom of buttons.
15
12 ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.
13
14
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
Used to select fan speed in four steps low, medium, high and CHAOS.
5 JET COOL
Used to start or stop the speed cooling. (Speed cooling operates super high fan speed in cooling mode.)
6 CHAOS SWING BUTTON
Used to stop or start louver movement and set the desired up/down airflow direction.
START/STOP BUTTON
Operation starts when this button is pressed and stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON Used to select the operation mode.
ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
Name and Function-Remote Control
The remote control transmits the signals to the system.
1
Remote Control
2
Signal transmitter
3
4
5 1 6
3
4
2
7
11
8
13
15
|
| 7 | ON/OFF TIMER BUTTONS | |
| 10 |
| Used to set the time of starting and stopping operation. | |
CANCEL |
|
| ||
9 | 8 | TIME SETTING BUTTONS | ||
ON OFF SET | ||||
12 | Used to adjust the time. | |||
| 9 | TIMER SET/CANCEL BUTTON | ||
|
| |||
| 14 |
| Used to set the timer when the desired time is obtained | |
| 16 |
| and to cancel the Timer operation. | |
|
| SLEEP MODE AUTO BUTTON | ||
|
| 10 | ||
|
|
| Used to set Sleep Mode Auto operation. |
11
Operation Mode
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
• Cooling Model(), Heat Pump Model(
)