State Industries U287-084, 705 Series 200 Mounting the Controller, OutlineofofControllRem ter

Page 32

Temperature Controller Installation

Mounting the Controller

Follow the procedure below to install additional controllers.

1.	Determine a suitable location for the
	controller.
2.	Make three holes in the wall as shown.
3.	Run the cable between the controller and the
	water heater or the controller and the other
	controller.
4.	Remove the face plate from the temperature
	controller using a screwdriver.
5.	Connect the cable to the temperature
	controller.
6.	Mount the controller to the wall using the
	holes drilled in step 2.
7.	Disconnect the power from the water heater.
8.	Remove the cover of the water heater.

OutlineofofControllRem ter

9.	Remove the plastic cover from the PCB and
	electrical connections.
10.	Thread the cable through the access hole at
	the base of the unit and connect the wires to
	the controller terminals on the right hand side
	bottom of the PCB.
11.	Secure the controller cable using the clamp
	provided.
12.	Replace plastic cover over PCB and then

securing screw

wiring hole

securing screw

1-21/32"

3-5/16"

replace the cover of the water heater.

REMOTE CONTROL

CONNECTION TERMINALS

REMOTE

CONTROL CABLE

CABLE CLAMP

32	305, 505, 705 Indoor Manual

Image 32

Contents Models 305 505 705 ANS Z21.10.3 CSATable of Contents Specifications Model 305 505 705Safety Behavior and Practices Safety Features Consumer Safety InformationSafety Definitions Features Available on Temperature Controllers FeaturesDescription of Operation Operating InstructionsSetting the Temperature Temperature Options Without a Temperature ControllerTemperature Ranges Setting Controller to MuteModel Temperature Settings Available ºF Re-setting the Maximum TemperatureMaintenance Code Fault Remedy Error CodesError Code Table Code Water Quality Trouble Shooting for Common IssuesAccessing Operating Information Flushing the Heat Exchanger Error Code LC or Water HeaterInstallation Instructions General InstructionsClearances from Appliance Attachment of the Water HeaterGeneral Instructions Electrical ConnectionGas Piping Pipe Sizing Procedure Example Freeze Protection Water PipingPressure Relief Valve Freeze Protection Piping Water HeaterRecommended Piping for Basic Installation QTYRecommended Piping for Circulation Systems For this applicationOptional Piping for Circulation Systems For this applicationCondensate Venting InstructionsIntake / Exhaust Guidelines Maximum Vent Length Venting Products Listed and Tested Vent Products for the 305 and 505 ModelsListed and Tested Vent Products for the 705 Model Manufacturer Product PartsVent Terminal Area Where Terminal is not Permittted Flue Terminal Clearances ANS Z21.10.3 CSAAdditional Clearances Vent Terminal Inside CornerFlue Installation for the 305 and 505 Models Flue Installation for the 705 Model Air Intake AssemblyExhaust Pipe Assembly Venting Clearances to CombustiblesHorizontal with Concentric Termination Vertical TerminationsHigh Altitude Installations Connecting Multiple Water HeatersNumber of Connected Water Heaters Accessories Necessary GuidelinesTemperature Controller Installation ConfigurationsLocation Cable Lengths and SizeMounting the Controller OutlineofofControllRem terFor Your Safety Read Before Operating Operating InstructionsOutlet Flow Data Technical DataPressure Drop Curve Temperature Setting ReplacementSpace Heating PumpsDimensions 505 ModelsLadder Diagram HOTWhat will be done? WarrantyWhat is covered? Limitation on implied warranties How do I get service?What is not covered? U287-084