State Industries U287-084, 705 Series 200 installation manual Setting the Temperature

Page 6

Setting the Temperature

1. Press the “Priority button” on the temperature controller. The green Priority light will glow indicating that this controller is controlling the temperature and that the water heater is ready to supply hot water.

The priority can only be changed while no hot water is running.

2.Press the ▲ or ▼ buttons to obtain the desired temperature setting.

All hot water sources are able to provide water at this temperature setting until it is changed again at this or another temperature controller.

Temperature Options Without a Temperature Controller

The default temperature setting for this appliance installed without a temperature controller is 120º F (49º C). If desired the temperature setting can be changed to 140º F (60º C) by adjustment of a dip switch.

Set dip switch 5 to ON to obtain 140º F water temperature setting.

Set dip switch 5 to OFF (default) to obtain 120º F

120º F (49º C)								140º F (60º C)

	Switch No.								Switch No.
					ON								ON
	O				ON				O				ON
	O					1			O						1
	F					2			F						2
	F								F
	F								F
						3									3
						4									4
						4									4
						5									5
						5									5
						6									6
						6									6
						7									7
						7									7
						8									8
						8									8

6	305, 505, 705 Indoor Manual

Image 6

Contents Models 305 505 705 ANS Z21.10.3 CSATable of Contents Specifications Model 305 505 705Consumer Safety Information Safety DefinitionsSafety Behavior and Practices Safety Features Description of Operation Features Available on Temperature ControllersFeatures Operating InstructionsSetting the Temperature Temperature Options Without a Temperature ControllerModel Temperature Settings Available ºF Temperature RangesSetting Controller to Mute Re-setting the Maximum TemperatureMaintenance Error Codes Error Code TableCode Fault Remedy Code Trouble Shooting for Common Issues Accessing Operating InformationWater Quality Flushing the Heat Exchanger Error Code LC or Water HeaterInstallation Instructions General InstructionsClearances from Appliance Attachment of the Water HeaterElectrical Connection Gas PipingGeneral Instructions Pipe Sizing Procedure Example Water Piping Pressure Relief ValveFreeze Protection Freeze Protection Piping Water HeaterRecommended Piping for Basic Installation QTYRecommended Piping for Circulation Systems For this applicationOptional Piping for Circulation Systems For this applicationVenting Instructions Intake / Exhaust GuidelinesCondensate Maximum Vent Length Listed and Tested Vent Products for the 705 Model Venting ProductsListed and Tested Vent Products for the 305 and 505 Models Manufacturer Product PartsVent Terminal Area Where Terminal is not Permittted Flue Terminal Clearances ANS Z21.10.3 CSAAdditional Clearances Vent Terminal Inside CornerFlue Installation for the 305 and 505 Models Exhaust Pipe Assembly Flue Installation for the 705 ModelAir Intake Assembly Venting Clearances to CombustiblesHorizontal with Concentric Termination Vertical TerminationsNumber of Connected Water Heaters Accessories Necessary High Altitude InstallationsConnecting Multiple Water Heaters GuidelinesLocation Temperature Controller InstallationConfigurations Cable Lengths and SizeMounting the Controller OutlineofofControllRem terFor Your Safety Read Before Operating Operating InstructionsTechnical Data Pressure Drop CurveOutlet Flow Data Space Heating Temperature SettingReplacement PumpsDimensions 505 ModelsLadder Diagram HOTWarranty What is covered?What will be done? How do I get service? What is not covered?Limitation on implied warranties U287-084