State Industries U287-084, 705 Series 200 Additional Clearances Vent Terminal, Inside Corner

Page 26

Additional Clearances - Vent Terminal

Local codes supersede these clearances.

•Avoid termination locations near a dryer vent.

•Avoid termination locations near commercial cooking exhaust.

Vent terminal (represents concentric vent terminal for the water heater)

12"

(0.30 m ) to an inside corner

(0.91 m) to ventilated or unventilated soffit

36" or eve vent; or to a deck or porch

VV 12"

V

(1.52 m) vertically 60" between water heater

terminals

V

(0.30 m) between water heater terminals at same level

INSIDE

CORNER

24" (0.61 m) to wall or parapet

V

(1.52 m) between water heater terminals at different levels

V

60"

V

	12"		(0.30 m) between water
	V	V	heater terminals at same
	V	V	level
			level

26	305, 505, 705 Indoor Manual

Image 26

Contents Models 305 505 705 ANS Z21.10.3 CSATable of Contents Specifications Model 305 505 705Safety Behavior and Practices Safety Features Consumer Safety InformationSafety Definitions Description of Operation Features Available on Temperature ControllersFeatures Operating InstructionsSetting the Temperature Temperature Options Without a Temperature ControllerModel Temperature Settings Available ºF Temperature RangesSetting Controller to Mute Re-setting the Maximum TemperatureMaintenance Code Fault Remedy Error CodesError Code Table Code Water Quality Trouble Shooting for Common IssuesAccessing Operating Information Flushing the Heat Exchanger Error Code LC or Water HeaterInstallation Instructions General InstructionsClearances from Appliance Attachment of the Water HeaterGeneral Instructions Electrical ConnectionGas Piping Pipe Sizing Procedure Example Freeze Protection Water PipingPressure Relief Valve Freeze Protection Piping Water HeaterRecommended Piping for Basic Installation QTYRecommended Piping for Circulation Systems For this applicationOptional Piping for Circulation Systems For this applicationCondensate Venting InstructionsIntake / Exhaust Guidelines Maximum Vent Length Listed and Tested Vent Products for the 705 Model Venting ProductsListed and Tested Vent Products for the 305 and 505 Models Manufacturer Product PartsVent Terminal Area Where Terminal is not Permittted Flue Terminal Clearances ANS Z21.10.3 CSAAdditional Clearances Vent Terminal Inside CornerFlue Installation for the 305 and 505 Models Exhaust Pipe Assembly Flue Installation for the 705 ModelAir Intake Assembly Venting Clearances to CombustiblesHorizontal with Concentric Termination Vertical TerminationsNumber of Connected Water Heaters Accessories Necessary High Altitude InstallationsConnecting Multiple Water Heaters GuidelinesLocation Temperature Controller InstallationConfigurations Cable Lengths and SizeMounting the Controller OutlineofofControllRem terFor Your Safety Read Before Operating Operating InstructionsOutlet Flow Data Technical DataPressure Drop Curve Space Heating Temperature SettingReplacement PumpsDimensions 505 ModelsLadder Diagram HOTWhat will be done? WarrantyWhat is covered? Limitation on implied warranties How do I get service?What is not covered? U287-084