Kenmore 15718, 15218, 15616 Cleaning the Shuttle Race, Cleaning the shuttle area 1Bobbin case

Cleaning the Shuttle Race

This area must be kept free of dust, lint and tangled thread.

Clean the shuttle race area every three months.

•Cleaning the shuttle area _1_Bobbin case

,(2_Levers

,_3_Shuttle race cover '_4_Shuttle ,_5_Shuttle race

,(6_Center: pin on the shuttle

1.Raise the needle bar to its highest point, then and remove the bobbin case _1_.

2.Push the shuttle race levers _2_aside. Lift out the shuttle race cover _3_and take the shuttle _4_out.

3.Clean the shuttle race _5_with a lint brush.

4.Put a drop of oil on the center pin of the shuttle _ and the shuttle race _5_.Do not over oil.

J

• Replacing	shuttle assembly	f
_2_Levers
_3_Shuttle race cover
_4_Shuttle
_5_Shuttle race
_ Center pin on the shuttle
_7_Shuttle driver
'_8Pointed	hook

@ (Oil here)

1.Turn the handwheel so the shuttle driver _7_forms a half moon on the left side of the machine.

2.Hold the shuttle @ by its center pin _6_and, position the

shuttle so it forms a half moon on the right side. The hook_8_will be on the bottom.

3.Put the shuttle race cover _3_back into place over the shuttle assembly.

4.Snap the levers _2_back into the original position.

\\

...................f6b

J

74