Enviro Sonnet, C-11089 owner manual Kit Parts List, Conversion Kit Installation, Out of the firebox

Maintenance And Service

FUEL CONVERSION:

TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY

Please read and understand these instructions before installing.

Warning: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper or complete until the operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with the kit.

Kit Parts List:
1	- Orifice (Natural Gas #42 DMS or Propane #54 DMS)
1	- Conversion label	1 - Installation instruction sheet

Carefully inspect the orifice supplied with this conversion kit. If it has been damaged or is missing, contact your dealer, distributor or courier company to have them replaced before starting this installation.

Conversion Kit Installation:

1.Shut the gas supply off at the shut-off valve upstream of the unit. CAUTION: The gas supply must be shut off prior to disconnecting the electrical power and before proceeding with the conversion.

Allow the valve and unit to cool down to	Figure 19: Unfastening Burner.
room temperature.

2.Remove the glass door as shown in the MAINTENANCE AND

SERVICE - GLASS DOOR REMOVAL.

3.Carefully remove the log set and ember material if they are installed.

4.Using a T-20 screwdriver, remove the four (4) screws that hold the burner in place (pointed out in Figure 19). Slide the burner to the left (see Figure 20), then up and

out of the firebox. Figure 20: Burner Removal.

5.Convert the burner orifice:

a)Remove the main burner orifice with a 1⁄2 inch deep socket (see Figure 21).

b)Put a bead of pipe-thread sealant or approved Teflon tape on the orifice threads before installing into the brass elbow.

c)Install the new orifice from the kit into the brass elbow (see Figure 22).

6.Convert the pilot:

a) Using a	7/16” wrench, turn the pilot
		Figure 21: Orifice Removal.	Figure 22: Orifice
head a 1⁄4 turn counter-clockwise (shown in
			Replacement.
Figure 23).

14