Enviro C-11089, Sonnet owner manual Fan Kit Installation, Installing Power Cord

Page 25

Initial Installation

QUALIFIED INSTALLERS ONLY

Kit Contents:

Quantity

Description

Quantity

Description

 

 

 

 

1

Fan Assembly

1

Power Cord - 6ft (1.8m)

 

 

 

 

1

Wiring Harness

1

Star Washer

 

 

 

 

1

Temperature Sensor

1

#8-32 X 3⁄4” T-20 Screw

 

 

 

 

1

Fan Control; 3 Position Switch

 

 

 

 

 

 

Please ensure that all components are supplied with this kit. If components are missing or have been damaged, contact your dealer, distributor or courier company before starting this installation.

Fan Kit Installation:

1.Use a flat head screwdriver or 1⁄4” socket to remove the nine (9) screws holding the back cover on (see Figure 47).

2.Insert the power cord through the plastic bushing in the left cabinet side (refer to Figure 48), place the strain around the cord approximately 3” (76 mm) from the end, and insert into the fan mounting bracket with pliers (refer to Figure 49).

3.Ensure the wiring harness assembled according to Figure 45 and is attached to the fan.

Power Cord

Plastic Bushing

Strain Relief

Figure 48: Installing Power Cord.

Strain Relief

Power Cord

Fan Mounting

Bracket

Figure 49: Installing Power Cord & Strain Relief.

Figure 47: Removing Back Plate From Sonnet.

4.Hold the back panel close to the left side of the unit and hook the two (2) slots on the fan bracket over the rubber grommets found on the inside of the back panel (see Figure 50).

5.Ground the power cord to the unit using a star washer and T-20 screw (see Figure 51).

6.Slide the fan switch and temperature sensor part of the wiring harness under the firebox to the front of the unit.

7.Re-install the screws for the back cover.

Figure 50: Installing Fan onto Back Panel.

25

Image 25
Contents For Your Safety InstallerConsumer General Safety PrecautionsTable of Contents Vented GAS Fireplace Heater Sonnet BV/DV NG/LPG Codes And ApprovalsDimensions SpecificationsTrimmable Lighting and Turning OFF Instructions Operating InstructionsSetting C/24 hour or F/12 hour Clock Setting the TimeAutomatic Pilot Mode Adjustment of Flame HeightMAN Mode Manual Flame Height Adjustment Changing the Mode of OperationSetting the Temperature Setting the TimerComponent Sound & Reason Adjusting the venturi air settingPilot Flame Maintenance And ServiceReceiver Remote HandsetChanging Remote Handset Code Conversion Kit Installation Kit Parts ListOut of the firebox Each end that fit in to the brass nut but Mantle width and height Initial InstallationCan be started Vent Kit Installation Kit Contents Quantity DescriptionUnit Sheet metal screws evenly spaced KIT Components Installation InstructionsProper flame appearance. The amount of air Wall Bracket Top & Bottom Tools Required Fan wiring diagramInstalling Power Cord Fan Kit InstallationGas Line Connection Grounding Power CordOpening Inlet Pressure Tap on To Test Valve PressuresInstallation Secondary InstallationKit Contents Screw Hook Bracket To the Trim AssemblyMinimum size of Large Removal InstallationEnsure the Sonnet is turned off and allow the unit to cool Hook PlacementsEmpty firebox showing the ledges for the back logs Third Stage Log Set Installation Never operate the fireplace with the glass door removed Log Set and Ember InstallationProblem Possible Cause Solution Trouble ShootingValve’s Safety Possible Cause SolutionBV only Parts List ComponentsPart Description NumberReference Part Description Part Number ComponentsDiagramParts Parts Diagram Options Parts List OptionsReference Option Description Part Number To the Dealer WarrantyWarranty Installation Data Sheet