Secondary Installation
OPTIONAL CAST ANDIRON & GRATE:
A footing (i.e. Base Shelf) may need to be installed before the Cast Andiron is installed so that the Cast Andiron has something to sit on. Hook the Andiron assembly over the two (2) bushings near the bottom of the Sonnet, pointed out in Figure 66, and snap
them firmly down into place. When in place it will look similar to the image on the front cover of this Sonnet Owner’s Manual.
Note: The mounting brackets may need to be |
|
adjusted to fit onto the two (2) bushings. Loosen |
|
the screws on the brackets, adjust the brackets, and |
|
then | Figure 66: Hook Placements. |
BRICK PANEL INSTALLATION:
NOTE: The brick liner is fragile and should be handled gently.
1.Ensure the Sonnet is turned off and allow the unit to cool.
2.Remove the glass door as shown in the MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.
Warning: Do not touch or attempt to remove the glass if the fireplace is not completely cold. Never operate the fireplace with the glass removed.
3. Remove the log set and all ember material. |
| |
4. | Choose which brick pattern you would like to face |
|
| out. |
|
5. | There is a ledge at the back of the firebox (see |
|
| Figure 67). Place the back brick panel on the ledge |
|
| and ensure the panel is flush at the bottom and top |
|
| (refer to Figure 68). Do not push at the center of the |
|
| panel. |
|
6. | Slide the front of the left brick panel into the left lip |
|
| at the front of the firebox. Ensure the panel is flush to |
|
| Figure 67: Back Brick Panel Ledge. | |
| the side of the firebox and the back brick panel while | |
|
| |
| still being hooked behind the front lip (refer to Figure 69). Take care to not bump the brick panel on | |
| the burner. |
|
7.Repeat step 6 for right brick panel.
8.Install the log set and ember material (refer to SECONDARY INSTALLATION - LOG SET AND EMBER INSTALLATION) and the glass door.
|
|
|
Figure 68: Back Brick Panel in Place. |
| Figure 69: Side Brick Panels in Place. |
32