Hoover Commercial Spotter/Carpet Cleaner operating instructions Attach upper handle

1-2

Attach upper handle

Remove clean solution tank (upper tank).

1-3

With cord hook to back of cleaner, push upper handle down onto lower handle.

1-4

Push bolts into holes on front of handle.

If bolts will not go through hole easily handle is not pushed completely down.

1-5

Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely with a Phillips screw driver.

Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.

1-6

A

When handle sections are completely together, squeeze trigger (A) on upper handle to snap trigger rod in place.

1-7

Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.

1-8

Press cord into cord clip on back of handle.

Pull cord tight.

3