LOG PLACEMENT (3 LOG SET)
Before you begin: If you are installing logs into the DVP42 or DVP48 model then this fireplace is supplied with a set of three ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this fireplace. Sooting and other problems may result if the logs are not properly and firmly positioned in the fireplace.
Please refer to Figure 48A, Figure 48B, and Figure 49 and corresponding WARNING, when completing the following log placement steps.
1.Remove top louver, grasp louver, lift and pull forward.
2.Lower bottom louver, lift and hinge forward.
3.Release two glass frame spring clamps at bottom of firebox
4.Place bottom log onto main burner. Align holes on bottom log with (4) locator pins on burner.
5.Place rear log on rear log shelf. Place rear log so that the locator holes align with the (2) locator tabs in the log support shelf.
6.Place top branch onto flat area of rear log and over the front of the bottom log.
7.Place decorative rock in front of grates and sides of main burner.
ATTENTION: Do not place decorative rock on logs or on burner. The decorative rock should only be placed on the fireplace floor.
8.After all logs are properly positioned, place small "dime" size pieces of Rockwool lightly across the front round "blueflame" ports. Place the ember material (Rockwool pieces) side by side. Do not stack more than one layer of embers across the burner ports. See Figure 48A.
9.Replace glass door onto firebox.
10.Secure the two glass frame spring clamps at bottom of firebox.
11.Align the tabs on top louver brackets with slots in front posts to secure top louver.
12.Close bottom louver. Lift slightly to engage the end tabs into the slots in fireplace sides to close louver panel.
REAR LOG LOCATOR TABS
Figure 48A
EMBER PLACEMENT
BOTTOM LOG LOCATOR PINS
Page 28
Figure 48B
WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
Attention: Do not use Figure 48B or Figure 49 to order logs. Refer to parts view on page 45 and parts list on page 46 to order logs and/or ember material for your appropriate fireplace model.
TOP BRANCH
REAR LOG
BOTTOM LOG
Figure 49