Harman-Kardon AVR507 owner manual Speaker Selection, Speaker Placement

Page 17

Installation and Connections

Speaker Selection

No matter which type or brand of speakers is used, the same model or brand of speaker should be used for the front-left, center and front-right speakers. This creates a seamless front soundstage and eliminates the possibility of distracting sonic disturbances that occur when a sound moves across mismatched front-channel speakers.

Speaker Placement

The placement of speakers in a multichannel home-theater system can have a noticeable impact on the quality of sound reproduced.

Depending on the type of center-channel speaker in use and your viewing device, place the center speaker either directly above or below your TV, or in the center behind a perforated front-projection screen.

Once the center-channel speaker is installed, position the left-front and right-front speakers so that they are as far away from one another as the center-channel speaker is from the preferred listening position. Ideally, the front-channel speakers should be placed so that their tweeters are no more than 60cm above or below the tweeter in the center-channel speaker.

They should also be at least 0.5 meter from your TV set unless the speakers are magnetically shielded to avoid colourings on the TV screen. Note that most speakers are not shielded, even with complete surround sets only the Center speaker may be.

Depending on the specifics of your room acoustics and the type of speakers in use, you may find that imaging is improved by moving the front-left and front-right speakers slightly forward of the center-channel speaker. If possible, adjust all front loudspeakers so that they are aimed at ear height when you are seated in the listening position.

Using these guidelines, you’ll find that it takes some experimentation to find the correct location for the front speakers in your particular installation. Don’t be afraid to move things around until the system sounds correct. Optimize your speakers so that audio transitions across the front of the room sound smooth.

When the AVR is used in 5.1-channel operation, the preferred location for surround speakers is on the side walls of the room, at or slightly behind the listening position. In a 7.1-channel system, both side surround and back surround speakers are required. The center of the speaker should face you (see below).

Rear surround speakers are required when a full 7.1-channel system is installed, and they may also be used in 5.1 channel mode as an alterna- tive mounting position when it is not practical to place the main surround speakers at the sides of the room. Speakers may be placed on a rear wall, behind the listening position. As with the side speakers, the center of the rear surrounds should face you. The speakers should be no more than 2 meters behind the rear of the seating area.

Subwoofers produce largely nondirectional sound, so they may be placed almost anywhere in a room. Actual placement should be based on room size and shape and the type of subwoofer used. One method of finding the optimal location for a subwoofer is to begin by placing it in the front of the room, about 15cm from a wall, or near the front corner of the room. Another method is to temporarily place the subwoofer in the spot where you will normally sit, and then walk around the room until you find a spot where the subwoofer sounds best. Place the subwoofer in that spot. You should also follow the instructions of the subwoofer’s manufacturer, or you may wish to experiment with the best location for a subwoofer in your listening room.

Center Front Speaker

No more than 60cm

Left Front

 

Right Front

Speaker

 

Speaker

A)Front Channel Speaker Installation with Direct-View TV Sets or Rear-Screen Projectors

 

 

 

TV or Projection Screen

 

 

Left Front

Center Front

Right Front

 

Speaker

 

Speaker

Speaker

 

 

than 2m

-mounted

are used

 

 

No more

when rear

speakers

 

 

 

 

 

Optional Rear-Wall Mounting

 

B)The distance between the left and right

speakers should be equal to the distance from the seating position to the viewing screen. You may also experiment with placing the left and right speakers slightly forward of the center speaker.

Rear speaker mounting is an alternate location for 5.1 systems. It is required for 7.1 operation.

At least 15 cm from celling

At least 60 cm

INSTALLATION AND CONNECTIONS 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents AVR507 Limited Edition Audio/Video Receiver Declaration of Conformity Table of ContentsFront panel analog A/V inputs Description and FeaturesIntroduction Unpacking Safety InformationImportant Safety Information Front Panel Controls Information on digital audio # Preset Stations Selector Press thisDigital Input Selector When playing a Digital Audio Outputs Connect these Rear Panel Connections+ and negative terminals Unswitched OutletMain Remote Control Functions See page 32 for more information Channel/8 Channel Direct InputMovies ∆ Play Forward/Reverse/Stop ˚ Mute Zone II Remote Control FunctionsVideo Equipment Connections Installation and ConnectionsAudio Equipment Connections Video Input jacks Scart A/V ConnectionsVideo Connection Notes Important Note for Adapter CablesImportant Note for the Use SCART-Cinch Adapters If you use a unit providing RGB signals on aMain Room Remote Control Extension System and Power ConnectionsAC Power Connections Multiroom IR LinkSpeaker Selection Speaker PlacementUsing the On-Screen Display System ConfigurationSystem Setup First Turn OnSet Button Fto bring up the Speaker Setup menu Figure Input SetupSpeaker Setup Surround Within five seconds, either press the ‹/› buttons ¤ Button Dso that the cursor is next to Surround SetupOr 6.1/7.1 speaker output configuration is in use Stereo-Direct Bypass Mode Configuring the Surround Off Stereo ModesStereo-Digital Mode Delay SettingsOutput Level Adjustment Night Mode SettingsUsing EzSet Speaker/Channel IndicatorsSo that on is highlighted When all channels have the same output level Sensor and Indicator offUp the Volume until you can hear the test noise clearly Operation Surround Mode ChartMix of the in-phase material of the left and right channels No delay availableNo surround channels But no surround speakersChannel/8-Channel Direct Input Basic OperationSource Selection Volume Up/Down Buttons Surround Mode SelectionDolby Digital Digital Audio PlaybackPCM Audio Playback Selecting a Digital SourceDigital Bitstream Indicators Surround Mode TypesAudio, while the main feature is available PCM Playback IndicationsNight Mode Output Level Adjustment With Source SignalsNormal output level adjustment for Tape RecordingIndicator Select Memory BackupIndicator off Select to activate the sensorTurn On Volume Level Advanced FeaturesDisplay Brightness Surround Back/Multiroom SpeakerSemi-OSD Settings Advanced Features / Multiroom OperationFull-OSD Time Out Adjustment InstallationMultiroom Operation Multiroom SetupMultiroom Operation If the Remote IR Output jackBasic Tuner Operation Tuner OperationRDS Operation RDS TuningRDS Display Options Program Search PTYDirect Code Entry Programming the Remote with CodesTurn on the unit you wish to program into the AVR remote Must be repeated firstMacro Programming Programming the RemoteCode Readout Channel Control Punch-Through Volume Punch-ThroughProgrammed Device Functions Resetting the Remote Memory SPL Function ListAVR DVD Processor Reset Troubleshooting GuidePower Switch 1 is pushed Remote sensor ¯ is obscuredTechnical Specifications Harman Consumer International

AVR507 specifications

The Harman-Kardon AVR507 is a distinguished audio/video receiver that stands out in the realm of home entertainment systems. Launched in the early 2000s, the AVR507 quickly gained a reputation for its powerful performance, elegant design, and advanced feature set.

At the heart of the AVR507 is its robust amplifier section, delivering a substantial output power of 70 watts per channel across seven channels. This ensures immersive surround sound experiences that bring movies, music, and games to life with clarity and depth. The receiver supports various surround sound formats, including Dolby Digital and DTS, enabling users to enjoy cinematic audio quality right in their living room.

One of the key highlights of the AVR507 is its remarkable multi-zone capabilities. Users can setup different audio zones throughout their home, making it possible to play distinct audio sources in separate areas. This can be especially beneficial for larger homes or entertaining spaces where various preferences for music or audio may exist.

The AVR507 also boasts a comprehensive suite of connectivity options. With multiple HDMI inputs, component video, and optical audio inputs, it accommodates a wide range of devices, from Blu-ray players to gaming consoles. It also features an integrated AM/FM tuner, allowing users to enjoy their favorite radio stations without the need for additional equipment.

In terms of user experience, the receiver employs an intuitive on-screen graphical user interface, facilitating easy navigation through menus and settings. The included remote control offers convenient access to all of the AVR507's features, making for a smooth and user-friendly operation.

Another noteworthy technology within the AVR507 is its built-in digital signal processing (DSP), which enhances audio playback by optimizing sound quality based on the specific setup and speaker configuration. This ensures that whether you are watching a high-octane action film or listening to a subtle acoustic track, the audio remains balanced and rich.

The AVR507 also incorporates high-quality DACs (digital-to-analog converters) that are crucial for exceptional audio fidelity. The result is a receiver that not only excels in power and performance but also provides a refined listening experience.

In summary, the Harman-Kardon AVR507 is a versatile and powerful audio/video receiver that embodies a blend of advanced technology, user-centric design, and superb performance. Its multitude of features makes it an excellent choice for anyone looking to elevate their home entertainment experience.
Top Page Image Contents