Harman-Kardon AVR507 owner manual Front Panel Controls

Front Panel Controls

¯	(		˜	Û $	ˆ	&	ı	Ù Ú
	DIGITAL EX	LOGIC 7			VID 1	DVD
	PRO LOGIC				VID 2	CD
	3 STEREO	DSP			VID 3	FM
		7 CH. STEREO		SBL SBR	VID 4	TAPE
		SURR. OFF				8 CH

1 3	8 5		) ! 7	%	* Ó		
2	4 6	9	7 @ #		^	Ô	Ò

1 Main Power Switch

2 System Power Control

3 Power Indicator

4 Headphone Jack

5 Surround Mode Group Selector

6 Speaker Select Button

7 Selector Buttons

8 Tone Mode

9 Surround Mode Selector

)Tuning

!Tuner Band Selector	ÔVideo 4 input jacks
@Set Button	Bass Control
#Preset Stations Selector	ÒBalance Control
$Speaker/Channel Input Indicator	ÚTreble Control
%Input Source Selector	ÛDigital Input Selector
^RDS Select Button	ÙChannel Select Button
&Delay	ıVolume Control
*Digital Optical 3 Input	ˆInput Indicators
(Surround Mode Indicators	˜Main Information Display
ÓDigital Coax 3 Input	¯Remote Sensor Window

1 Main Power Switch: Press this button to

apply power to the AVR. When the switch is

pressed in, the unit is placed in a Standby

mode, as indicated by the orange LED 3. This

button MUST be pressed in to operate the unit.

To turn the unit off completely and prevent the

use of the remote control, this switch should be

pressed until it pops out from the front panel so

that the word “OFF” may be read at the top of

the switch.

NOTE: This switch is normally left in the “ON” position.

2System Power Control: When the Main Power Switch 1 is “ON,” press this button to turn on the AVR; press it again to turn the unit off (to Standby). Note that the Power Indicator 3 will turn blue when the unit is on.

3Power Indicator: This LED will be illuminated in orange when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn blue.

4Headphone Jack: This jack may be used to listen to the AVR’s output through a pair of head- phones. Be certain that the headphones have a standard 6.3 mm stereo phone plug. Note that the speakers will automatically be turned off when the headphones are connected.

5Surround Mode Group Selector: Press this button to select the top-level group of surround modes. Each press of the button will select a major mode grouping in the following order:

Dolby Modes ➜ DTS Digital Modes ➜ DSP Modes ➜ Stereo Modes ➜ Logic 7 Modes

Once the button is pressed so that the name of the desired surround mode group appears in the Main Information Display ˜, press the Surround Mode Selector 9to cycle through the individual modes available. For example, press this button to select Dolby modes, and then press the Surround Mode Selector 9 to choose from the various mode options.

6Speaker Select Button: Press this button to begin the process of selecting the speaker positions that are used in your listening room. (See page 18 for more information on setup and configuration.)

FRONT PANEL CONTROLS 5