Briggs & Stratton 073004 WP15-225 manuel dutilisation Emissions Control System Warranty

Page 20

EMISSIONS CONTROL SYSTEM WARRANTY

Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB)

and the United States Environmental Protection Agency (U.S. EPA)

Emissions Control System Warranty Statement

(Owner’s Defect Warranty Rights and Obligations)

California, United States and Canada Emissions Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and B&S are pleased to explain the Emissions Control System Warranty on your small off–road engine (SORE). In California, new small off–road engines model year 2006 and later must be designed, built and equipped to meet the State’s stringent anti–smog standards. Elsewhere in the United States, new non–road, spark–ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. B&S must warrant the emissions control system on your engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off–road engine.

Your emissions control system includes parts such as the carburetor, air cleaner, ignition system, fuel line, muffler and catalytic converter. Also included may be connectors and other emissions related assemblies.

Where a warrantable condition exists, B&S will repair your small off–road engine at no cost to you including diagnosis, parts and labor.

Briggs & Stratton Emissions Control Defects Warranty Coverage

Small off–road engines are warranted relative to emissions control parts defects for a period of two years, subject to provisions set forth below. If any covered part on your engine is defective, the part will be repaired or replaced by B&S.

Owner’s Warranty Responsibilities

As the small off–road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instructions. B&S recommends that you retain all your receipts covering maintenance on your small off–road engine, but B&S cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off–road engine owner, you should however be aware that B&S may deny you warranty coverage if your small off–road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off–road engine to an Authorized B&S Service Dealer as soon as a problem exists.The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a B&S Service Representative at 1–414–259–5262.

The emissions warranty is a defects warranty. Defects are judged on normal engine performance.The warranty is not related to an in–use emissions test.

Briggs & Stratton Emissions Control Defects Warranty Provisions

The following are specific provisions relative to your Emissions Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non–regulated engines found in the Owner’s Manual.

1.Warranted Parts

Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased.

a.Fuel Metering System

Cold start enrichment system (soft choke)

Carburetor and internal parts

Fuel Pump

Fuel line, fuel line fittings, clamps

b.Air Induction System

• Air cleaner

• Intake manifold

c.Ignition System

Spark plug(s)

Magneto ignition system

d.Catalyst System

Catalytic converter

Exhaust manifold

Air injection system or pulse valve

e.Miscellaneous Items Used in Above Systems

Vacuum, temperature, position, time sensitive valves and switches

Connectors and assemblies

2.Length of Coverage

B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the failure of the Warranted Parts for a period of two years from the date the engine is delivered to a retail purchaser.

3.No Charge

Repair or replacement of any Warranted Part will be performed at no charge to the owner, including diagnostic labor which leads to the determination that a Warranted Part is defective, if the diagnostic work is performed at an Authorized B&S Service Dealer. For emissions warranty service contact your nearest Authorized B&S Service Dealer as listed in the “Yellow Pages” under “Engines, Gasoline,” “Gasoline Engines,” “Lawn Mowers,” or similar category.

4.Claims and Coverage Exclusions

Warranty claims shall be filed in accordance with the provisions of the B&S Engine Warranty Policy.Warranty coverage shall be excluded for failures of Warranted Parts which are not original B&S parts or because of abuse, neglect or improper maintenance as set forth in the B&S Engine Warranty Policy. B&S is not liable to cover failures of Warranted Parts caused by the use of add–on, non–original, or modified parts.

5.Maintenance

Any Warranted Part which is not scheduled for replacement as required maintenance or which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall be warranted as to defects for the warranty period. Any Warranted Part which is scheduled for replacement as required maintenance shall be warranted as to defects only for the period of time up to the first scheduled replacement for that part. Any replacement part that is equivalent in performance and durability may be used in the performance of any maintenance or repairs. The owner is responsible for the performance of all required maintenance, as defined in the B&S Owner’s Manual.

6.Consequential Coverage

Coverage hereunder shall extend to the failure of any engine components caused by the failure of any Warranted Part still under warranty.

Image 20
Contents Model Equipment Description Table of ContentsSafety Rules Unintentional sparking can result in fire or electric shock Operate water pump only outdoorsSafety Rules Engine Speed Lever Used to adjust engine speed to Know Your Water PumpEngine Information not shown Stamped on valve Strainer Basket not shown Used to limit passageAssembly Carton ContentsUnpack Water Pump Add Engine OilAttach Suction Hose Attach Discharge HoseAttach Suction Hose to Pump Attach Suction Hose to Strainer BasketUsing the Water Pump What is Head?Safe Operating Considerations Move Water Pump to Safe Operating LocationPrime the Water Pump Locate Strainer Basket Into Water SourceStarting the Water Pump Choke Lever shown in Choke positionStopping the Water Pump Drain and Flush Water PumpProduct Specifications Power RatingsEngine Technical Information ModelMaintenance Schedule MaintenanceCleaning General RecommendationsOil Oil RecommendationsChecking Oil Level Adding Engine OilService Spark Plug Service Air CleanerTo service the air cleaner, follow these steps Oil Fill OpeningClean Spark Arrester Screen Air Cooling SystemStorage Long Term Storage InstructionsWater Pump Other Storage TipsTroubleshooting Problem Cause CorrectionPage Emissions Control System Warranty Owner’s Warranty ResponsibilitiesPage Page Limited Warranty Table DES Matières Description DE LéquipementMise EN Garde Règles DE SécuritéLors DU Réglage OU DES Réparations DE Votre Pompe À EAU Avertissement Étiquette du numéro de série Connaître Votre Pompe À EAUOrifices dévacuation Assemblage Déballage de la pompe à eauContenu de la boîte Ajout de lhuile à moteurFixation du boyau daspiration Fixation du boyau dévacuationFixation du boyau daspiration à la pompe Fixation du boyau daspiration au panier-filtreDéplacement de la pompe vers un emplacement sécuritaire Utilisation DE LA Pompe À EAU AvertissementPour un fonctionnement sécuritaire Quest-ce que la hauteur?Amorçage de la pompe à eau Localisation du panier-filtre dans la source deauLinterrupteur est illustré en position On Démarrage de la pompe à eauPoussez linterrupteur ON/OFF sur On Figure Arrêt de la pompe à eau Vidange et rinçage de la pompe à eauRenseignements Techniques SUR LE Moteur Caractéristiques DU ProduitPuissance nominale ModèleRecommandations générales Calendrier DentretienContrôle des émissions EntretienRecommandations relatives à l’huile HuileVérification du niveau dhuile Ajout d’huileEntretien du filtre à air Entretien de la bougie dallumageCartouche Base CouvercleNettoyage de lécran pare-étincelles Système de refroidissement à airEntreposage Directives dentreposage à long termePompe à eau Autres conseils dentreposageProblèm Cause Solution DépannageGarantie DU Dispositif Antipollution Page Garantie Limitée Índice Descripción DEL EquipoPrecaución Normas DE SeguridadCuando Pruebe LA Bujía DEL Motor Quemaduras severas pueden ocurrir al hacer contacto Conozca SU Bomba DE Agua Depósito de combustibleMontaje Desembalaje de la bomba de aguaContenido de la caja Añadir aceite del motor Añadir combustibleFijación de la manguera de aspiración Conexión de la manguera de descargaConexión de la manguera de aspiración a la bomba Conexión de la manguera a la cesta del filtroUSO DE LA Bomba DE Agua Advertencia Consideraciones para un uso seguroColocación de la bomba de agua en una posición segura Espacio libre y circulación de aireVuelva a colocar el tapón de la bomba Cebado de la bomba de aguaColocación de la cesta del filtro en la fuente de agua Puesta en marcha de la bomba de agua RápidoEstrangular FuncionamientoParada de la bomba de agua Vaciado y limpieza de la bomba de aguaInformación Técnica Sobre EL Motor Especificaciones DEL ProductoPotencia nominal ModeloPlan DE Mantenimiento Recomendaciones generalesControl de emisiones MantenimientoAceite Recomendaciones sobre el aceiteComprobación del nivel de aceite Adición de aceite del motorPara revisar el filtro de aire, siga estos pasos Revisión del filtro de aireRevisión de la bujía Limpieza de la pantalla apagachispas Sistema de refrigeración de aireAlmacenamiento Instrucciones de almacenamiento a largo plazoBomba de agua Otras sugerencias para el almacenamientoResolución DE Problemas Problema Motivo SoluciónNotas Garantía DEL Sistema DE Control DE Emisiones = 250 horas, B = 500 horas y a = 1000 horas Uso del consumidor Uso comercial

073004 WP15-225 specifications

The Briggs & Stratton 073004 WP15-225 is a powerful and efficient water pump designed to tackle a variety of dewatering tasks. Engineered with durability and performance in mind, this pump is ideal for homeowners, contractors, and outdoor enthusiasts looking for a reliable solution for managing water removal from puddles, flooded basements, or construction sites.

At the heart of the WP15-225 is a robust 225cc Briggs & Stratton engine that generates ample power to move large volumes of water quickly. With a pumping capacity of up to 3,000 gallons per hour, it can handle substantial dewatering projects with ease. The engine is designed for easy starting, thanks to the reliable recoil start system, ensuring that users can get to work without delays.

One of the standout features of the WP15-225 is its cast iron volute and impeller, which provide superior durability and resistance to corrosion. This construction not only extends the lifespan of the pump but also enhances its efficiency during operation. The pump is capable of lifting water from depths of up to 25 feet, making it an effective solution for a range of applications.

The WP15-225 also includes a user-friendly design with ergonomic handles for easy transportation, coupled with a lightweight frame that makes it convenient to move around job sites. The integrated transport kit allows users to maneuver the pump effortlessly, delivering convenience on the go.

Furthermore, the pump features a durable, large-capacity fuel tank that ensures extended operation between refueling, minimizing downtime for the user. Its adjustable discharge feature allows for versatile operation, accommodating different discharge hose sizes and lengths, which is particularly useful for varying project requirements.

Safety features are not overlooked; the pump includes a low-oil shutdown mechanism that protects the engine from damage, ensuring longevity and reliable performance. The design has been tailored to minimize vibration, resulting in reduced user fatigue during extended use.

In summary, the Briggs & Stratton 073004 WP15-225 is a reliable, high-performing water pump that combines powerful engineering with user-friendly features. With its robust construction, efficient pumping capability, and thoughtful design elements, it stands out as a top choice for anyone in need of an effective solution for water management tasks. Whether it's for residential or commercial use, the WP15-225 is built to meet the demands of any dewatering challenge.