Briggs & Stratton 073004 WP15-225 Engine Technical Information, Product Specifications, Model

Page 12

SPECIFICATIONS

ENGINE TECHNICAL

INFORMATION

These water pumps are powered by a single cylinder, overhead valve (OHV), air cooled, low emissions engine.

In the State of California, these water pump engines are certified by the California Air Resources Board to meet emissions standards for 250 hours. Such certification does not grant the purchaser, owner or operator of this engine any additional warranties with respect to the performance or operational life of this engine.The engine is warranted as stated elsewhere in this manual.

Power Ratings

The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002-05). Given both the wide array of products on which our engines are placed, and the variety of environmental issues applicable to operating the equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a piece of power equipment (actual “on-site” power).This difference is due to a variety of factors including, but not limited to, the following: differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication, maximum governed engine speed, individual engine to engine variability, design of the particular piece of power equipment, the manner in which the engine is operated, engine run-in to reduce friction and clean out of combustion chambers, adjustments to the valves and carburetor, and other factors.The power ratings may also be adjusted based on comparisons to other similar engines utilized in similar applications, and will therefore not necessarily match the values derived using the foregoing codes.

PRODUCT

SPECIFICATIONS

Model 073004

Water Pump Specifications

 

Suction Port Diameter

1.5 in (38 mm)

Discharge Ports Diameter

 

2 @

. 1 in (25 mm)

2 @

1.5 in (38 mm)

Total Head

. 225 ft (69 m)

Maximum Head

 

Suction Lift

. . . 25 ft (8 m)

Discharge Lift

. 200 ft (61 m)

Maximum Discharge Capacity . 132 US gal (500 l) per minute

Shipping Weight

. . . . . . . . . . . . . . . . . . . . . . 75 lbs.

Engine Specifications

 

Rated Horsepower

. . . . . . . . . . . . . . 5.5 at 3600 rpm

Bore

. . . . . . . . . . . . . . 2.69 in. (68mm)

Stroke

. . . . . . . . . . . . . . 2.20 in. (56mm)

Displacement

. . . . . . . . . . . . . 12.48 in. (206 cc)

Spark Plug

 

Type:

Champion RC12YC or Equivalent

Set Gap To:

. . . . . . . . . . . 0.030inch (0.76mm)

Armature Air Gap:

. . . . . . . . . . . . . . . 0.010-0.014 in.

 

(0.25-0.36mm)

Valve clearance with valve springs installed and piston 1/4 in.

(6 mm) past top dead center of compression stroke (check when

engine is cold).

 

Intake

0.004-0.006 in.

 

(0.10-0.15 mm)

Exhaust

0.009-0.011 in.

 

(0.23-0.28 mm)

Fuel Capacity

. 1 U.S. gallons

Oil Capacity . . . . . . . . . . . . . . . . . . . .20 Ounces (.6 Liters) Oil Type:

Above 40° F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .SAE 30 Below 40° F . . . . . . . . . . . . . . . . .SAE 5W-30 or 10W-30

NOTE: For practical operation, the horsepower loading should not exceed 85% of rated horsepower. Engine power will decrease 3-1/2% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F (5.6° C) above 77° F (25° C). It will operate satisfactorily at an angle up to 15°.

12

Image 12
Contents Model Table of Contents Safety RulesEquipment Description Unintentional sparking can result in fire or electric shock Operate water pump only outdoorsSafety Rules Engine Speed Lever Used to adjust engine speed to Know Your Water PumpEngine Information not shown Stamped on valve Strainer Basket not shown Used to limit passageAssembly Carton ContentsUnpack Water Pump Add Engine OilAttach Suction Hose Attach Discharge HoseAttach Suction Hose to Pump Attach Suction Hose to Strainer BasketUsing the Water Pump What is Head?Safe Operating Considerations Move Water Pump to Safe Operating LocationPrime the Water Pump Locate Strainer Basket Into Water SourceStarting the Water Pump Choke Lever shown in Choke positionStopping the Water Pump Drain and Flush Water PumpProduct Specifications Power RatingsEngine Technical Information ModelMaintenance Schedule MaintenanceCleaning General RecommendationsOil Oil RecommendationsChecking Oil Level Adding Engine OilService Spark Plug Service Air CleanerTo service the air cleaner, follow these steps Oil Fill OpeningClean Spark Arrester Screen Air Cooling SystemStorage Long Term Storage InstructionsWater Pump Other Storage TipsTroubleshooting Problem Cause CorrectionPage Emissions Control System Warranty Owner’s Warranty ResponsibilitiesPage Page Limited Warranty Table DES Matières Description DE LéquipementMise EN Garde Règles DE SécuritéLors DU Réglage OU DES Réparations DE Votre Pompe À EAU Avertissement Connaître Votre Pompe À EAU Orifices dévacuationÉtiquette du numéro de série Assemblage Déballage de la pompe à eauContenu de la boîte Ajout de lhuile à moteurFixation du boyau daspiration Fixation du boyau dévacuationFixation du boyau daspiration à la pompe Fixation du boyau daspiration au panier-filtreDéplacement de la pompe vers un emplacement sécuritaire Utilisation DE LA Pompe À EAU AvertissementPour un fonctionnement sécuritaire Quest-ce que la hauteur?Amorçage de la pompe à eau Localisation du panier-filtre dans la source deauDémarrage de la pompe à eau Poussez linterrupteur ON/OFF sur On FigureLinterrupteur est illustré en position On Arrêt de la pompe à eau Vidange et rinçage de la pompe à eauRenseignements Techniques SUR LE Moteur Caractéristiques DU ProduitPuissance nominale ModèleRecommandations générales Calendrier DentretienContrôle des émissions EntretienRecommandations relatives à l’huile HuileVérification du niveau dhuile Ajout d’huileEntretien du filtre à air Entretien de la bougie dallumageCartouche Base CouvercleNettoyage de lécran pare-étincelles Système de refroidissement à airEntreposage Directives dentreposage à long termePompe à eau Autres conseils dentreposageProblèm Cause Solution DépannageGarantie DU Dispositif Antipollution Page Garantie Limitée Índice Descripción DEL EquipoPrecaución Normas DE SeguridadCuando Pruebe LA Bujía DEL Motor Quemaduras severas pueden ocurrir al hacer contacto Conozca SU Bomba DE Agua Depósito de combustibleMontaje Desembalaje de la bomba de aguaContenido de la caja Añadir aceite del motor Añadir combustibleFijación de la manguera de aspiración Conexión de la manguera de descargaConexión de la manguera de aspiración a la bomba Conexión de la manguera a la cesta del filtroUSO DE LA Bomba DE Agua Advertencia Consideraciones para un uso seguroColocación de la bomba de agua en una posición segura Espacio libre y circulación de aireCebado de la bomba de agua Colocación de la cesta del filtro en la fuente de aguaVuelva a colocar el tapón de la bomba Puesta en marcha de la bomba de agua RápidoEstrangular FuncionamientoParada de la bomba de agua Vaciado y limpieza de la bomba de aguaInformación Técnica Sobre EL Motor Especificaciones DEL ProductoPotencia nominal ModeloPlan DE Mantenimiento Recomendaciones generalesControl de emisiones MantenimientoAceite Recomendaciones sobre el aceiteComprobación del nivel de aceite Adición de aceite del motorRevisión del filtro de aire Revisión de la bujíaPara revisar el filtro de aire, siga estos pasos Limpieza de la pantalla apagachispas Sistema de refrigeración de aireAlmacenamiento Instrucciones de almacenamiento a largo plazoBomba de agua Otras sugerencias para el almacenamientoResolución DE Problemas Problema Motivo SoluciónNotas Garantía DEL Sistema DE Control DE Emisiones = 250 horas, B = 500 horas y a = 1000 horas Uso del consumidor Uso comercial

073004 WP15-225 specifications

The Briggs & Stratton 073004 WP15-225 is a powerful and efficient water pump designed to tackle a variety of dewatering tasks. Engineered with durability and performance in mind, this pump is ideal for homeowners, contractors, and outdoor enthusiasts looking for a reliable solution for managing water removal from puddles, flooded basements, or construction sites.

At the heart of the WP15-225 is a robust 225cc Briggs & Stratton engine that generates ample power to move large volumes of water quickly. With a pumping capacity of up to 3,000 gallons per hour, it can handle substantial dewatering projects with ease. The engine is designed for easy starting, thanks to the reliable recoil start system, ensuring that users can get to work without delays.

One of the standout features of the WP15-225 is its cast iron volute and impeller, which provide superior durability and resistance to corrosion. This construction not only extends the lifespan of the pump but also enhances its efficiency during operation. The pump is capable of lifting water from depths of up to 25 feet, making it an effective solution for a range of applications.

The WP15-225 also includes a user-friendly design with ergonomic handles for easy transportation, coupled with a lightweight frame that makes it convenient to move around job sites. The integrated transport kit allows users to maneuver the pump effortlessly, delivering convenience on the go.

Furthermore, the pump features a durable, large-capacity fuel tank that ensures extended operation between refueling, minimizing downtime for the user. Its adjustable discharge feature allows for versatile operation, accommodating different discharge hose sizes and lengths, which is particularly useful for varying project requirements.

Safety features are not overlooked; the pump includes a low-oil shutdown mechanism that protects the engine from damage, ensuring longevity and reliable performance. The design has been tailored to minimize vibration, resulting in reduced user fatigue during extended use.

In summary, the Briggs & Stratton 073004 WP15-225 is a reliable, high-performing water pump that combines powerful engineering with user-friendly features. With its robust construction, efficient pumping capability, and thoughtful design elements, it stands out as a top choice for anyone in need of an effective solution for water management tasks. Whether it's for residential or commercial use, the WP15-225 is built to meet the demands of any dewatering challenge.