Frigidaire Air Conditioner manual To USE the Energy Saver YOU will see Feature, Then OO this

Operating Instructions

(continued)

TO USE THE ENERGY SAVER	YOU WILL SEE:
FEATURE:

temp/timer

DO THIS;

PRESS

MODE BUTTON

CHOOSE

ENERGY SAVER

Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 seconds at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on.

TIMER: DELAY	STOP / START		YOU WILL SEE HOW MUCH TIME
FEATURE			IS	CHOSEN:
		tamp/timer I		temp/timer
			THEN
OO THIS;			DO THIS:
			PRESS
PRESS				@
	_i	_	UP/DOWN
FIRST
TIMER BUTTON		_	SET BUTTONS

Note: For Delay Stop, the unit must be in the On position.

Note: For Delay Start, the unit must be in the Off position.

First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( A ) or the DOWN arrow ( V ) to change delay timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time

remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,

Energy Saver, or Fan Only was the last mode selected) or heating with maximum Fan speed (if Heat was the last mode selected.

Note: On 115V models

only low

speed

can

be selected.)

The

temperature

maintained

will be the same as previously set. To change

the set temperature,

press

"COOL"

then

Up or

Down

arrows

until

the

desired

temperature

is indicated

on the display. After

5

seconds,

the control

will

automatically

change

the display

back

to

the

hours

remaining

until the unit will start/stop.

Pressing

the

unit On/Off button at

any

time

will

cancel

the

Delay

Start/Stop

function.

The

Delay

Start/Stop Feature will work until the unit either

starts or

stops. Once

that

happens

the

above

steps

have

to be

repeated

again.

SLEEP

FEATURE:

YOU WILL

SEE:

temp/timer

remote

sensmg

DO THIS;

PRESS

SLEEP BUTTON

temp/timer

remote

sensing

Note: In this mode the selected temperature will increase by 2 °F 30 minutes after the mode is selected. The temperature will then increase by another 2 °F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected temperature. This ends the "Sleep" mode and the unit will continue to operate as originally programmed.

The "Sleep" mode program can be cancelled at any time during operation by again pressing the "Sleep" button.

@2009 Electrolux Home Products, Inc. All rights reserved.